Von Schweikert VR-4JR Bi-Wire

Another possibility is to go with the two seperate cable runs then cover/combine them in inexpensive cable covering from Home Depot - usually costs about $2.50/10' run available in the electrical department - and doesn't look any worse than any other cables while permitting you to reach both modules easily.

The advantage of doing this is that it saves you the cost of replacing cables if you decide later to bi-amp the VR4JRs which is what I did and it really makes the sing.

The Analysis Plus Oval 9s are a great match for the JRs and richer-sounding IMHO than the Kimber TCs; both of which I've used. But I found I like the sound of the JPS Labs speaker cables MUCH better than either of the former cables - more open, detailed and natural sounding.

One tweak to seriously consider is Herbies Big Fat Black Dots to replace the small spike interface between the upper and lower modules. They offer a big improvement in detail retreival and imaging on what already superb speakers.

I like the idea of Canare 4S11. I have used it with great success. That said, I now use Speltz anti-cables in two runs from the amps to the speakers. SInce that does not appeal to you, you would most likely get the same result by running one pair to the lower module and another pair to the upper posts. The wire retains its bent shape and you can hide it behind the speakers. Any magnet wire would probably do, but I wanted mine pre-terminated, and they are not expensive. The terminals on the 4JRs should handle both set of spades, or you can order them with bananas, or bare wires, or call them and they can rig up the set with only one spade each for the lower module. By this I mean one spade with two wires running to it and two different length wires. Good luck!

Verbatim speaker cables for sale were just posted. Research them on the Forums and you'll find that VS used (still uses?) the cables at many shows. I don't know how the 25" thing will work, but Albert Von Schweikert speaks highly of the match with his speakers. The cables are made by Paul Varner at
verbatim1@earthlink.net

Acoustic Zen will make one run a little longer for you if you went them.....however, I second the Herbies Big Fat Black Dots VS Special once you get your cable situation straighten out, just did it to mine a few weeks back and it was truely amazing what it did to for my sound.....

I had these same speakers and did in fact run the Analysis Plus sivlers biwire version. These cables start out as connected (all 2/4 cables) at the point that they connect to the amp but split immediately at this point so that you have no problem attaching these to the VR 4 JR.

Additionally, I found that with my other equipment at the time that the silver cables were a good match with the VS VR 4 JRs. Look for a pair of the Analysis Plus used and inquiry or request a pic from the seller.