Which Preamp will go well with Mag 3.6R ?

"Macdadtexas,

>>> 7BSST's (really the same thing as the 14bsst) >>

I jsut noticed this,,,
7BSST is almost same as 14BSST???

I can get 7B at half the price of 14B. (actually the 7B is the same price as 4B !)

So 7BSST will do fine?"

The 7BSST amp is a monoblock so you will need 2 of them so I highly doubt you will find a "pair" priced lower than a 14BSST amp or the same as a 4B amp. You are probably looking at the price of a single 7B amp (where you will need 2 of them)...

The 14BSST is pretty much 2 7B amps in one chassis although given it is a single chassis it does not have the total capacitance that 2 7BSST monoblocks will give you but that may not matter in your application. I have a 14B-SST amp mated to my 1.6 Maggies and it does a great job and can confidently advise it will do the same with a pair of 3.6's.

ONE more dumb question :

Then, can I use TWO 4BSST instead of ONE 14BSST?

Can I use two 4Bsst to double up power?

I tried a 4bsst with my 3.6r's and the sound in my room was a bit bright and lacking in bass.Not enough power.
Along came my Classe CA-400 that puts out 800w at 4 ohms and all is well.Used prices for these are in the low 2K range.

The Classe CAM350 as you listed would be an excellent match for a smooth sound.

Agree with Bob reynolds and Ackman00. You should audition the Parasound JC 1's. They great sounding amp's. Check out Stereophile January 2010 issue. M. Fremer compare them to Bryston 7Bsst'2, he likes the Parasound JC 1 better. According to John Atkinson's measurement test. The Bryston's has low input impedance that may be problem matching with preamp specialy tube pre and in his measurement into 2-ohms load the Bryston 7Bsst'2 didn't do as well as the other amp's tested.

I had the Parasounds in my system a few years back, I really loved those too. Excellent choice. I don't know that I liked them better than the Bryston's, because they were a couple iterations of amps apart, but I did really like both of them.