XLR Interconnect as digital cable

Hello actually i have very good result with a pair of Purist Audio Design Praesto Revision Proteus Provectus in a 1.5 M. length (XLR,AES/EBU) that i use as a single wire between my ZANDEN DRIVE and my lovely JADIS JS1 dac. I use this cable on a temporaly basis waiting for my other DIGITAL PAD single wire (25 th aniversary) to be redone in BNC at the Zanden end. I discover that the Zanden accept only BNC mode and XLR mode. My actual digital is RCA to RCA. I was amaze how good this split pair sound so good.
Not too much technical explanation i can provide on this experience but it do really work well................

Sometimes you just get lucky and something works better than expected.

Back to the first response - can it possibly do damage? Otherwise it is certainly worth a try

I'd be very surprised if any damage were to result. The only way I can envision damage occurring would be if the cable connected one of the two signals in the balanced signal pair (which would be on XLR pins 2 and 3) to ground (XLR pin 1), which would be highly unusual and probably indicative of a defect, AND if the output circuit of the component driving the cable could not tolerate a short to ground (despite the current limiting effect of its 110 ohm output impedance).

If you have a multimeter, or convenient access to one, you could easily check the cable for shorts (and open connections as well).

Regards,
-- Al

Thanks