2. analog
  3. 1325551242

Eminent Technology ET-2 Tonearm Owners


Where are you? What mods have you done ?

I have been using these ET2's for over 9 years now.
I am still figuring them out and learning from them. They can be modified in so many ways. Bruce Thigpen laid down the GENIUS behind this tonearm over 20 years ago. Some of you have owned them for over 20 years !

Tell us your secrets.

New owners – what questions do you have ?

We may even be able to coax Bruce to post here. :^)

There are so many modifications that can be done.

Dressing of the wire with this arm is critical to get optimum sonics along with proper counterweight setup.

Let me start it off.

Please tell us what you have found to be the best wire for the ET-2 tonearm ? One that is pliable/doesn’t crink or curl. Whats the best way of dressing it so it doesn’t impact the arm. Through the spindle - Over the manifold - Below manifold ? What have you come up with ?
128x128ct0517
slaw's avatar
slaw
22,029 posts
 
Bigalt: My hearing isn't like it once was either.

The saving grace is.. even though humans' listening range doesn't go past 20Khz, an lp has the ability to go to 40khz. This can't be heard but can be experienced!!!!

The once reported range of digital doesn't come close.
slaw's avatar
slaw
22,029 posts
 
Ct0517: Bigalt's 8 tt's should not surprise you. I think it is more of a "I wish I was there" factor. ha ha. (Shhhhh... you are very, very close)
slaw's avatar
slaw
22,029 posts
 
Bigalt: I think you, and maybe, only you, can appreciate the 3.5 platter/bearing and other mods I've done to my TT. Despite your pronouncement that you may not be able to hear nuances, I think you can at least appreciate your past history/vs/current going's on.

I'd LOVE to see your system!
slaw's avatar
slaw
22,029 posts
 
Bigalt: Reading (further) into your comment "and the sound it provides" makes me think that, you could provide all of us great insight on, (what I hope) are your further comments based on your (obvious) long history with analog, (specifically the ET).
richardkrebs
422 posts
 
Slaw.

Taking a look at your systems page, I see a nice compressor setup with aux receiver. A few questions please...

What is the total volume of the two receivers? You get impressive cycle off time, more than a typical LP side, which has to be a good thing.

Also, is it an oil less compressor? If not, any concerns about oil vapour getting into the arm? Obviously the filter and separator are inline to protect against this, but we worry about such things don't we.

Many thanks
More to discover