The death of an amplifier

Oh GAWD!

This is silly - pressure washers and religion and liquid and airy sound. Nonsense!!! Everybody knows that to preserve the life of a SS amp you must put a piece of fresh meat on top of it periodically. Use only beef, lamb, or pork. NO CHICKEN - not even if it is free range! It is time to change the meat when it a turns light shade of taupe. Do not leave the meat until it is green - that is just plain cheap.

For tube amps, place a bowl of cooked lima beans on top each week, and keep the beans hydrated. Smear uncooked duck fat on the face plate and sides of the amp. If you use 300B tubes (or are just looking for a little extra insurance) smear the uncooked duck fat on your chest and forehead and dance naked at sundown on your front lawn/porch/balcony/roof to further appease the audio gods.

Hope that helps.

Okay Nate, I will answer your question. If you do not kill the amp by shorting the speaker leads, running too-low impedances,(or pressure washing it), and it is left to its own demise, the capacitors will generally be the first thing to break down. Electrolytics typically are the first to go. Usually in the power supply section. Also generally, the hotter an amp runs, the faster it will cause the passive components to fail. We are talking about SS amps here, so I am not talking tube life or anything. Of course, any part could fail at any time, so there are no guarantees. But, the things I mentioned would be typical. The other common failure item is the on/off switch.

Damn I guess I should use the cut & paste deal when I have had a few drinks this way little mishaps like that will be averted.

Twl- Thanks for getting us back on track.

Tom, are the things you mentioned preventable or can I take preemptive action? Will I be able to hear capacitors that are on the way out? The Aragon amp does not run real hot. It is warm to the touch but it is not in a rack. There is nothing immediately above or below it. It is about four inches above the floor with nothing above till the ceiling.
As far as the on/off switch, the only time I turn anything off is on the rare occasion when I move equipment around or when I am going away for a while. If there are things I can do to extend the life of these toys I would be interested. Thanks for your help.