The death of an amplifier


When an amplifier finally passes away what is usually the cause for it's demise? Can this be prevented? I'm looking to do some preventative maintenence. HELP!
128x128nrchy
Okay Nate, I will answer your question. If you do not kill the amp by shorting the speaker leads, running too-low impedances,(or pressure washing it), and it is left to its own demise, the capacitors will generally be the first thing to break down. Electrolytics typically are the first to go. Usually in the power supply section. Also generally, the hotter an amp runs, the faster it will cause the passive components to fail. We are talking about SS amps here, so I am not talking tube life or anything. Of course, any part could fail at any time, so there are no guarantees. But, the things I mentioned would be typical. The other common failure item is the on/off switch.
Damn I guess I should use the cut & paste deal when I have had a few drinks this way little mishaps like that will be averted.

Twl- Thanks for getting us back on track.
Tom, are the things you mentioned preventable or can I take preemptive action? Will I be able to hear capacitors that are on the way out? The Aragon amp does not run real hot. It is warm to the touch but it is not in a rack. There is nothing immediately above or below it. It is about four inches above the floor with nothing above till the ceiling.
As far as the on/off switch, the only time I turn anything off is on the rare occasion when I move equipment around or when I am going away for a while. If there are things I can do to extend the life of these toys I would be interested. Thanks for your help.
Nate, no they are really not preventable, but keeping the heat low will help. You can quite often tell if a cap is going bad by some sonic indications, but it is possible that a cap won't fail first. It may be a resistor, or output transistor or anything. Since you don't really know what item will be first to fail, for sure, you can't do too much to prevent it, other than good general care, and using the amp within its design parameters(not pushing overly low impedances especially). After that, it's just the luck of the draw.
Actually, Religon is operated by the same folks that run Audiogon. It specializes in the sale of relics: antique furniture, spiritual items, old wives....

will