If i had the money.....

Oops, ERATA, I mistakenly wrote the LAMMS do 200wpc CLASS A into 4 ohms. LAMM owners only wish, heh heh...

You are right Frank, The LAMMs do 100wpc pure CLASS A into 4 ohms. That is still pretty amazing since most amps cut actual Class A Power by about 75% if ohms are decreased by half. Thus if a typical amp is 100wpc Class A into 8 ohms, the amp would be effectively 25wpc class A into 4 ohms (the rest of the power would be AB).

Please correct me if my understanding is incorrect.

KF

Check out the 250lbs Classe Omega. I think it was like something 100wpc class a, 500wpc in a/b. then like 3400wpc into some crazy low impedence. that's nuts.

Aroc: I've heard from more than a few folks, including straight from a Classe' dealers own mouth, that the Omega's are not that good sounding. Like anything else though, it is a matter of system synergy and personal preference.

I also had a response typed up to Tok2000 and Twl but it somehow disappeared from my computer. Must have happened when it locked up earlier today. Sean
>

Sean,
I am surprised that you are spending so much time looking at specs. You know better than most, it is the sound.

I personally love Krell amps. Although the specs don't change that much as I have upgraded over the years, the sound has.

Richard

The "sound" of a unit has to do with the design of the circuit, how the circuit is laid out and the quality of the parts used. A good portion of what one hears can be described in specs IF one is provided with ALL of the pertinent specs. By "pertinent specs", i'm not talking about the typical stuff that is provided in a buyers guide either.

If the specs check out phenomenally good without having to resort to "tricks" such as high negative feedback, etc.. and one doesn't like the sound of the product, it is quite simple to alter the sonics of such a unit by changing passive parts.

What do you think that most of these "tweak guru's" do for a living ? Most of them leave the circuitry as is ( for the most part ) and simply swap higher grade components in place of what the manufacturer used. This is work that a monkey could do for the most part. It is only when one gets into altering circuit design that knowledge of circuitry comes into play.

The fact that this unit is built like a tank, has a good basic design, careful attention to parts layout and hand selected high grade parts for every inch of the circuit tells me that it should be pretty close to what you can get out of a SS circuit. Like anything else, i'm sure that it could be improved in more than a few ways. It makes life a LOT easier if you start off with something that is "solid" to begin with though.

The first thing that would have to go on these amps would be the binding posts. I'd also like it if if was a little bit faster too : ) Sean
>