How to interpret the readings from tube tester?

It depends on which tube tester is being used. Eico, Hickock, B&K, SICO all have different values. Also, good testers test for more than just tube strength. It gets quite confusing. That's why I would suggest buying from a reputable dealer if you are have trouble with different readings. Try www.tubesandmore.com, thetubestore.com, or upscaleaudio.com. They usually only sell new tubes and if selling used, will teach you about individual readings.

Generally 104+ on a TV-7 indicates new spec for a 6SN7. (2600 umhos). 98/99 - a little lower than "new" but still very good, may be new in fact, since not all tubes (nor testers) will always test exactly the same.

BTW, forget Upscale Audio for 6SN7s (and 6DJ8/6922s) unless you have bought gear from them. They will only sell ho-hum NOS tubes (e.g. Russian crap) in those types, unless you have bought gear from them that uses those tubes, then you get the "special cookie jar" tubes. No other sellers (including myself) have this sort of first class/second class when it comes to buying and selling.

All IMHO of course,
-Ed

A more pertinent question is how does one know the tube tester is accurate/calibrated?

As far as what is left in the tube, the Gm readings will give you a feel of the tube, not any with definite certainty of what's left in it. A good way to figure out how much life is left, the tube should be tested at a lower voltage. For example, test the 6SN7 at both 6 volts and 5 volts. If the Gm remains constant during the switch, the tube still has a good deal of life left. Some tube testers have a switch that reduces the voltage between 5% and 10% during a test - if the reading remains constant, it indicates a good tube; this way you don't have to worry about interpreting specific mho numbers - just the change (or lack of).

Again, what comes out of the amp can be totally independent of what is tested, and you cannot say with absolute confidence that a higher value tube will sound better or last longer than a lower one. It's a crapshoot, buying old tubes.

In additon to Ga5556's point "matching" is different for different circuits/amps. I just bought an old Citation to fool around with. Matching cathode currents, which is what most people mean isn't that important. You do not want them way off but you are looking for close Gm (transconductance).

I'm harldly an expert on all the different circuits and such but matching is not one thing and also a lot of tubes are matched in conditions that do not match how they are going to be used (voltages/currents) and so the "matching" tells you less than one would think and often they are tested/matched without proper warm up etc...

I remain,