2. amps-preamps
  3. 1068473970

Subwoofer Amp Recommendations

I've added a stereo pair of VBT Magellan passive subs (fantastic, BTW)to my 2-channel system. VBT recommends using their 200S amp, which I have---and it is good---and I could get another for stereo, but as I'm using a Tact 2.2x, I don't need the crossover/volume functions in their amp, and would rather not have to put the signal through another set of electronics.

My considerations have ranged from the new Carver Pro amps (but I'm not happy about their connections as I'd need new cables or adapters) to used Adcoms/NADs/Aragons. I've also considered PS Audio and Sunfire, but not sure if I need to spend that much just for a bass amp.

A friend suggested the new Panasonic 45 digital receiver which takes a digital input (saving me the expense of a DAC, but I already have an extra anyway).

Your thoughts and experience would be appreciated.
richards
eldartford
4,262 posts
 
Ritteri...My point about slew rate is that a subwoofer signal does not involve any "sudden changes", so the ability of an amp to track such changes is immaterial.

The Kenwood LO7M is a true DC amp, with not a single capacitor in the signal path. If you put a steady voltage on the input, say +0.1vdc you will get a steady voltage say +20vdc, at the output. It is truly linear down to DC, unlike the Aragon which you say rolls off (probably minus 3dB) at 5 Hz.

Is response only to 5Hz adequate? Sure, but you are the one who raised the issue of bandwidth below 20 Hz. I am sure that your Aragon is a very fine amp, but its virtues would be wasted driving a subwoofer.
danner
202 posts
 
... for a description of damping factor and how it works try: www.crownaudio.com/pdf/amps/damping%20factor.pdf
elgordo
530 posts
 
I'll second Eldartford's recommendation of the Kenwood L-07M. If you've never heard these as bass amps, you should. Absolutely fantastic!
eldartford
4,262 posts
 
Elgordo..."One man right (or even two men) is a majority of one". In their day the LO7M were considered the best. By now they are all well burned in...and still working!

I have the service manual if anyone is interested. They are flat from DC to 50 Khz +0 -0.5 dB, and to 100KHz +0 -1dB.
Not too shabby.
ritteri
223 posts
 
Not too shabby on paper, but the Kenwoods had problem with induced noise and had a very poor quality control on their mfg. tolerances. Kenwood=cold solderjoint problems. And an amp thats 25+ years old isnt going to get any better. If they were truely that great, they would still be making them, or something that resembled their original design concept.

BTW slew rate is just as importnat for a bass as it is for midrange or treble. I personally like detailed bass that integrates seamlessly into the rest of the audio spectrum. Its a given fact that alot of amps with low slew rates have muddy bass in comparison.
More to discover