What 5ch or 3/2 to match Aragon 8008bb?

Kincade
Sorry for butting in again. :) NO you are not incorrect in your assumption of the Klipsch/Aragon amps. The older Aragon/Acurus amps of the mid to late '90's is the way to go. Just my 2 cents.
Paul

Oh man, you're not butting in! I'm LOOKING for advice!

I actually purchased a Sherbourn 7.2100, and haven't even taken it out of the box yet. I just was thinking that I might as well try to get into a better amp if I'm able, so that I don't have to worry about this for a while yet.

So basically I can go with either this route:

8008BB for mains (8008st as an alternative) - $1150 ish
8008x3 for the center and 2 surrounds - $1350 ish
Acurus A250 or 200 for rear surrounds - $600 ish
Total cost of $3100

OR, go with an 8008BB for the mains - $1150ish
And 8008x5 for the other 5 - $2000 ish

Either way I'm in about $3k...

Is either preferable?

I keep reading about the 4004 series too, but I can't find much info about them.

On another note; how are these amps triggered? do the autosense the signal, have a 12v trigger, or do I have to manually turn them on? I can't find the info on the klipsch website anywhere.

Thanks for all the advice!

I don't know why many seem to think the new Aragon amps are not as good as the old. Internally, they're all still the same; only the outer cosmetics are different. Having owned both(still have an 8002 and 8008BB), the Acurus products don't have anywhere near the dynamics and lower noise floor of the Aragon products. I even bi-amped a pair of Paradigm Eclips/BP's with 2 Acurus A200 amps, then switched to the 8002- the 8002 was far superior in every way, all by itself.
Stick to the 8008x5.

Hi Kincade
To my knowledge the 4004 Doesn't get close to the 8008BB. Re: triggering - You do have to turn them on manually - when they're off - they're off. No stand by. I happen to like that.
I would go with the seperate amps. Two reasons. 1. Much better chanel seperation. Not to mention that you will have MUCH more actual current, available per channel. 2. IF by chance a channel goes bad somehow, you are not completely "out of business". Let me know how things go.
Paul

Kincade,

You have to manually turn them on. I had a 4004 markII and an 8008BB (pre-klipsch). I dumped them both and picked up a sherbourn 7/2100 and haven't looked back. Processor is an Anthem AVM20 and speakers have included B&W N805's and N805Sigs, VR4jr's and Soliloquy 5.3i's. Cables are cardas golden cross and sources are Xindak SACD2 and modded Philips 963SA.

Good luck,