MIT continued experience

06-26-15: Nmmusicman
Over the years, I've always found a consistent synergy with MIT cables and AQ cables when used together. I mainly use AQ DBS interconnects with MIT Shotgun speaker cables

---

Same here.

I had the full loom of either Audioquest or MITs and found a goldilocks combination using AQ Jaguar ICs with DBS and MIT Shotgun S2 speaker cables.

Been that way for a couple of years with very good results, imho, of course.

any of you guys using MIT cabling w/ THIEL loudspeakers?
I would be interested in reading about the synergy (if any)
and your listening impressions/thoughts?

Keep me posted & Happy Listening!

"07-06-15: Jafant
any of you guys using MIT cabling w/ THIEL loudspeakers?
I would be interested in reading about the synergy (if any)
and your listening impressions/thoughts?"

I would be careful. Since the signal leaving the network box is different for the highs and the lows, I would be concerned that this would have an effect on the speakers time and phase characteristics.

That's not correct. The components in the network boxes are wired in parallel with the signal cable. One of the points of having a network box is to have correct signal(s) at all frequencies.

"07-07-15: Psag
That's not correct. The components in the network boxes are wired in parallel with the signal cable. One of the points of having a network box is to have correct signal(s) at all frequencies."

Then why do they label the outputs on the network box high and low? Are you saying that both outputs are the same and it doesn't matter how you connect them?