Replacing internal wiring.


For all those people spending big bucks on speakers cables , ever check into replacing the internal wiring in speakers or the amps?

Most but not all have cheap wiring inside, and does not even compare to whats on the outside, I was thinking about rewiring my speakers, with some kimber or audioquest using WBT solder thoughout.

Also doing the same operation on the amps, inside the amp is just a matter of replaceing some 12" jumper spades that would be super easy compared to the speaker over haul.

Let me know what you think
infwgf
I've moddified several pair of speakers simply by matching component values with upgraded polypropylenes and using mostly Kimber VS wire as it's decent, not too expensive and can be broken apart from the braid to fit into small solder holes.
I have to only assume, that it would improve the speakers sound, I have done it on some Tannoy speakers, that had super cheap wire with some audioquest type 4 and I found out that it improved the sound. Also doing the same to a pair of NHT super ones, it helped out also. I would be replacing wire that is basicly cheap stuff like monster cable, with Audioqeust CV4 for the speaker and Kimber 4tc or 8Tc for the amp.

The larger gauge audioquest wire is huge ( like my Caldera ), and would be hard to put in the amp, but some kimeber 8tc, has a large gauge but smaller package, also so does 4tc.
I have done this on my Spica's and on my JBL L-166's, and yes, it does help a little bit.. a little smoother, a little less hash-y. I would NOT recommend replacing wire in an amp unless the amp's designer is consulted or it's a mod others have done repeatedly with successful improvement. Also I just finished working with some silver solder and some large 10 gauge mult-strand solid core copper wire and I had to use a 100 watt iron and it really had to heat up the wire before that silver solder would melt! good luck.
Xiekitchen, what kind of silver solder ? Some of it won't melt or bond for ANYTHING. I use an 800* tip and some silver based solders still won't "grab" very well on some metals.

I have re-wired amps, preamps, speakers, etc... Sometimes, the results are subtle, sometimes they are staggering. One thing is for certain. You should document EVERYTHING ( which wire goes where, what direction, etc... ) before even attempting to remove anything. This will allow you to go back to where you first started on the whole thing or replace just one part. Keep in mind that all of the wiring and connections will take a bit of use to fully settle in, so don't go off the deep end right away if you're not thrilled. Sean
>
The idea is OK, but the length of the wire inside the amplifier and speaker is generally much shorter than that of the speaker cables, and so I would expect that it is less critical to have such high quality wire inside the amp and speakers. It should make a difference, but I would expect the difference to be much less marked than upgrading the speaker cable itself. These reasons have always put me off doing any such mods.