Current Trends in multi thousand dollar speakers


Have any of you been paying attention to the current trends in larger multi-woofer speakers that cost multiple thousands of dollars? So that many of you can follow along, i'll use the Legacy Focus 20/20's at $6K, the Piega C8's at $15K and the Aerial 20T's at $23K as points of reference. All of these have been reviewed in Stereophile over the last few months. If you're not familiar with these, all of them are vertical dynamic designs using multiple woofers in vented cabinets.

If you look at the response of of these speakers, they all have very pronounced bass peaks with elevated low frequency plateau's taking place. Of these three, the Legacy's are by far the worst of the bunch. Not only do they diverge from neutrality the most ( +7 dB peak @ 100 Hz ), their elevated bass output or "low frequency plateau" levels out at 40 Hz and at 400 Hz. That is over 3+ octaves of "extra" output that wasn't on the recording. Above 400 Hz, the output levels off with very noticeable rippling slightly above that point in the midrange and multiple large peaks with a dip up in the treble response. Below 40 Hz, the output drops like a rock. The reason that the plateau levels out at 40 Hz is because of the associated sharp roll-off associated with vents below their point of resonance.

To sum things up, this speaker, which Paul Bolin raved about in Stereophile, is anything but "smooth" or "linear" in reproduction. As can be seen in the graphs, there is a very definite "boom & sizzle" type of response taking place here. As a side note, i found that the Legacy Signature III's showed a similar large bass peak centered at appr 100 - 110 Hz, so this would seem to be a consistent design attribute / "house sound" / "family voice" to Legacy speakers.

Moving onto the Piega's, their overall response looks to be measurably smoother than the Legacy's from the midrange on up. As far as bass goes, the Piega's peak occurs at an amplitude of +5 dB's and is centered at appr 85 Hz. Their "bass plateau" is quite wide, actually just as wide as that of the Legacy. Both show the same appr "elevated output" aka "bloat" from about 40 Hz to 400 Hz. Much like the Legacy's, the Piega shows the typical sharp roll-off below 40 Hz due to the output of the vent being out of phase with that of the undamped woofer. Even though both speakers show very similar plateau's and a similar F3 ( -3 dB point ), the Legacy's bass plateau has both a higher peak and a higher average.

Moving up to the $23K price range, we've got the Aerial 20T's. Similar to the Piega's, the Aerial's are reasonably smooth in response from the mids on up with a few low amplitude peaks and dips. Side by side comparisons though, it would appear that the Piega's are a little "flatter".

When it comes to low frequency performance, the Aerial's produced a +5 db peak centered at appr 60 Hz. Of the three speakers mentioned here, the amplitude of the peak is the same of the Piega's ( +5 dB's ), which is much lower ( 66% reduction ) than that of the +7 dB peak of the Legacy's. Even with this 66% reduction of the peak amplitude at resonance compared to the Legacy's, we are still talking about a divurgence of +5 dB's here!!!

As far as the "bass plateau" goes with the 20T's, this speaker is much more linear than either of the above. While the Aerial's also level out at appr 40 Hz and drop like a rock below that point, the upper end of the bass region is MUCH smoother. Whereas the others were contributing added output up to appr 400 Hz, the Aerial's are leveling out at appr 120 Hz or so. In effect, the Aerial's appear to offer the most controlled bass with the least amount of bass colouration. Then again, they are by far the most expensive also.


As far as low frequency extension is concerned, the Aerial's resonance peak is centered the lowest of the three i.e. 60 Hz for the Aerial's vs 85 Hz for the Piega's and 100 Hz for the Legacy. Even though the Aerial's have a resonance that is 25 Hz below that of the Piega's and 40% lower in frequency than the Legacy's, all of their -3 dB points are within a very few Hz of each other. While the graph's aren't completely legible, it appears that the F3 ( -3 dB point ) for all of these speakers are right about 34 - 38 Hz or so. How do such different designs achieve similar F3's? It has to do with the tuning of the vents and the amplitude of the peaks at resonance.

By creating a huge peak at resonance, it takes longer for the amplitude of the signal to fall off. As such, the Legacy's much larger peak at resonance allows it to achieve appr the same F3 on paper that the other designs worked harder to achieve. As such, were the Legacy's designed this way because they like the sound of massive bloat? Were they designed this way so that they could claim a lower F3? Could it be a combo of the two? We'll probably never know.

What does all of this add up to? Judged in comparison to each other and strictly talking about bass linearity, the Aerial looks the best on paper by far. Why just on paper? Because we have to factor in the added gain associated with in-room response. Our ears hear the entire presentation i.e. the speaker and how the speaker loads up / pressurizes & excites the room. As such, what looks the best on paper may not be what you like the most in your room. If you're room is properly set-up, the results on paper and the results in the room should pretty well jive. That is, at least as far as frequency response & linearity go. There are a LOT of other factors going on here though, not to mention personal preference.

What happens if the room isn't properly set up? Compared to anechoic responses, all speakers will have greater output / added extension when placed in an average listening room. While specific speaker placement comes into play in terms of the extension and amount of boost, most rooms will produce maximum ouput somewhere in the 50 - 80 Hz range. Obviously, this varies with the size and shape of the room.

The net effect is that these speakers are going to produce even MORE bass than what they already show in these graphs. Not only are we picking up low frequency output from what is called "room gain" ( "cabin gain" in a vehicle ) by pressurizing the room, we are also going to be exciting the resonances of the room too. All of this adds up to GOBS more "apparent bass". Add in the fact that this bass lacks speed and control* and you've got "bloated, ill-defined thump" running rampant.

Other than that, one has to wonder just how extended the bass response of these designs would be if they didn't have such HUGE peaks? After all, the higher the peak at resonance, the lower the -3 dB point of the speaker appears to be. Do we have to add "bloat" to get extension? How do you get around all of this and still keep good sound? That's easy but it is a completely different subject : )

What i want to know is, what do you folks think about this type of performance at these price levels? Is there anything that we can learn from this? Do we see a specific trend taking place here and in other parts of the audio market? Inquiring minds want to know : ) Sean
>

* vented designs all suffer from a lack of transient response, increased ringing, over-shoot and phase problems. In this respect, a well designed port is typically "more linear" than a passive radiator.
sean
Sean, There is an up side to this, these speakers with thier bass boost aught to sound really good with low level volume - no tone controls or equalizers needed here. :-) On a more serious note, perhaps in a really large room (and I assume some one who buys these really has a large room) the extra boost could be absorbed in the volume of the room - sort of the obverse of small speakers in a big room. Any chance? or is boom just boom?
Have any of you actually listened to the 20Ts at length? I have, in a suite which was non-ideal, @ CES. Numbers be damned, those are some *fine* sounding speakers. If I had the $ and space, I'd throw down for a pair in a second. One of the best dynamic speakers out there I think. Then again, nearly everything I have heard from Aerial shares this excellence. Are they expensive? Sure. But then again what isn't? I'd take this in a heartbeat over anything from Wilson or piega or legacy or whomever. It will be interesting to see if they start using the ribbon tweet further down the line...

-Ed
There was a big Legacy Focus discussion in this forum a while back. From some of the positive responses for the Legacy, I would have to agree with Sean's opinion that the market is driven by certain "Inaccuracies" in design to please the masses.
In the case of the 20T, JA tried to discount the bass peak somewhat with microphone level or something like that. He also noted the slight(and according to the chart-very slight)dip in the upper mids that he atributed it to what the reviewer heard in the response. I have seen much worse responses that JA has not said a negative word about in the testing of other speakers. The 20T was pretty darn flat in the world of speakers today through the mids and highs. The bass was pretty bad for a speaker at this price level. Of course I have never, ever liked ported designs. As Sean says, everyone of them are bumped up at a point to give the "Illusion" of extension so the roll off looks better.
I always thought "Hi-end" was about accuracy and truth to the source. I know a lot of people say accuracy isn't the only criteria and that is true. But, if you start with accuracy, add in neutrality and honesty to the source, I think you stand for having a speaker that performs well over a wider range of source material. It won't require so much tuning with cables, power cords, etc.
Richard Hardesty dedicated one of his Audio Perfectionist Journals to reading measured speaker performance. It was eye opening at the number of proven inaccurate speakers that were passed for being "Hi-end."
I personally believe you must start with accurate reponse across the frequency spectrum and then go from there. If you don't have accurate frequency response, then everything else is a moot point.
Are you saying that the response must be flat in order to be accurate? Which speakers out there are flat?
In the imperfect world of speakers, it would be nice to see a speaker at least within + or - 3db over a range of say 40-20k. The closer the speaker is to flat, yes, I believe it has a better chance at being accurate. As I stated, I believe everything must start with a accurate frequency response as possible, then go from there.
There is no perfect speaker but look at Vandersteen and Thiel for example. In a chamber, they are pretty dang flat (as the 20T was through the mids and highs.) Both these manufacturers(upper lines especially) hold their specs at + or - 1.5db from the upper 30's to at least 20k(1.2 in the case of the 5A.) In the case of the Vandersteen (and probably the Theil), they are matched within + or - .5db to each other or less.
The point here is, these manufacturer's have a proven accurate speaker(in todays world of accurate) at a much lower price point(especially in the case of Vandersteen.) You may not (and don't have to) like their sound, but they are accurate by any standard and built superbly to boot.
Look at the Legacy Focus 20/20. Do you feel + or - 10db to be accurate even if you think the speaker sounds good?