GMA Callisto VS. Merlin TSM

songwriter,
i responded to this comment earlier today but for some reason it did not get posted.
minbean is asking for first hand knowledge by those that have heard both speakers and you supply something that sounds a lot like mauimusic's assumptions on audio asylum. if you go by convention, then i would agree with you but the tsm does not exhibit a 3db hole at the crossover point in test or music reproduction. the gmas are very fine speakers imho. but they are one of many fine brands on the market today and perhaps if you were not as fixated on points of design, you might actually enjoy this hobby more. it is true that you may not like our product if you heard it but at least that would be fairer to all reading this.
regards,
bobby at merlin

Bobby, it is my understanding that the mathematics involved in a second order filter dictate that, at the crossover point, you have one leg that has gone 90 degrees inductive and the other leg has gone 90 degrees capacitive. The two legs are 180 degrees out of phase; one is leading and one is lagging. If you wire the drivers in the same phase on both sides of that crossover, what you end up with is a null at the crossover frequency. You say you have no null and wire the drivers in phase.

songwriter,
until you hear the speakers and have first hand knowledge of their sound and performance and can make a qualitative assessment of the entirety of these designs, i guess you'll just have to keep making assumptions and have me call you on them. "without taking sides on one or the other" quotes you from a message above and it is obvious that you have. enjoy your gmas, they are fine speakers. but, if you heard the tsms or vsms behind a black sheer and didn't know what they were, you would probably really like them. ;-)
there are more ways than one to get the job done.
regards,
bobby

The VSM was reviewed in stereophile at the link below, in the measurements section the VSM is seen to have one of the flatest frequency responses I've ever seen. Also, it can be seen that the drivers are connected in positive polarity.

http://www.stereophile.com//loudspeakerreviews/439/index.html

Troy

tarichar,
thank you for your post.
if you look at figure 9 and 11 and find the assocaited portions of the graph that relate to a -5 degree and 10 degrees off axis (approximate listing position/musical center) of the speaker then these are indeed very flat response curves. if you use the alignment tool to set them up you can move many feet from the right to left and have a stable image and only a substantial vertical move would cause a loss of hf and only to a degree.
regards,
b