High pass quality to mains uisng Velodyne DD subs


Hi,

For those who have incorporated one of the DD series subs into your two-channel system, did you use the line level high pass filter from the sub to your main speakers amp?

I have two sets of outputs from my preamp, so I could run one set to the sub and one set full range to my mains. I was just wondering if folks had experienced much degradation of signal going line level from preamp to DD to mains amp.

Theoretically, I like the idea of the high pass filter.

Getting ready to set up my dd18.

Regards,

Jerry
jerrym303
Rwwear,

I'm not following your last comment. The DD15 comes with the SMS built in. Are you not using the built-in low pass and equalization?
Yes it does and I am but I would like to have one just for the fact I could see the readout without a TV. And it will control other subs.
Eldartford, I guess your points make sense. By the way, the Velodyne high pass is also 6dB/octave.

Rwwear, I know what you say, but I would use the SMS-1 with my current REL and maybe an ACI Force later.
Hello Folks,

I own a DD15 and Dynaudio S1.4 speakers, and I have tried using the sub both ways.

Using the crossover and high passing the mains is the much better real-world choice. Every major sonic attribute is imrproved when you do this, all the way through to the midrange tone and transparency.

When you use the high pass, your midrange driver is freed from having to try and reproduce the bass along with the midrange in the same driver. The amplifier is also freed from the burden of dealing with the bass frequencies.

These advantages outweigh any theoretical "more circuitry in the signal path" problems by orders of magnitude.
Thanks for note goatwuss.

I'm going to try it out both ways when I get the chance and report on it.

Crossing over my front DLS 3-ways in my car a little higher made a huge difference there.