Rebbi, thanks for calling attention to the Dynamo review. I haven't received my copy of that issue yet, but I'm particularly struck by the mention of the amp's high output impedance. A 10.2 ohm output impedance/source impedance on the 8 ohm tap will cause the resulting sonics to vary DRAMATICALLY as a function of the impedance vs. frequency characteristics of the particular speaker that is being used. The most neutral behavior being likely to occur with speakers having impedances that are both relatively flat as a function of frequency and relatively high. That is true of most SETs, but to a considerably greater degree than usual in this case due to the uncommonly high output impedance.
The 4 ohm tap will have a lower output impedance, most likely around half of that value, or 5.1 ohms, which is still quite high.
I assume, btw, that since those numbers aren't specified at the Coincident website that they were told to him by Mr. Blume, as TAS (in contrast to Stereophile) doesn't usually perform such measurements.
On another note, like the others I am very much enjoying following your extremely well done blog.
Best regards,
-- Al
The 4 ohm tap will have a lower output impedance, most likely around half of that value, or 5.1 ohms, which is still quite high.
I assume, btw, that since those numbers aren't specified at the Coincident website that they were told to him by Mr. Blume, as TAS (in contrast to Stereophile) doesn't usually perform such measurements.
On another note, like the others I am very much enjoying following your extremely well done blog.
Best regards,
-- Al