Can good speakers take edge off digital?


I have a pair of Quad 12L2 speakers hooked up to an 845 SET. When I am listening to analog, the system sounds fine. But with digital, well, it has that bit of the digital edginess. Can a better pair of speakers, say the Zu Druid, take the edge off the digital?
toufu
I kind of figured it was my digital source, but isn't Monarchy NM24 one of the better digital sources? I just don't want to go spend a few grand on a player or dac and find out that it stll can't beat my $1000 turntable (Music Hall 5.1 with Goldring 1042).
Post removed 
Steakster and Bob are absolutely correct, clean power and a good power cord can make all the difference. Clean power and a nice power cord can make less than state of the art digital reach far above it's station. I would also investigate having the Monarchy modded, some nice capacitors, resistors and op amps go a long way, and much less expensive than a new DAC. Go with the power conditoner and cord first, I bet you'll be surprised.

I also use an 845 amp, using an 845 amp with those speakers should give you first rate sonics. Your preamp will also benefit from power conditioning. And then there are dedicated AC and isolation to think about, I know, it never ends!
I am completely on board with everyone who says to fix the offending problem - your digital front end.

A loudspeaker that would take the edge off the faults of your digital components is a loudspeaker I would never want in my system, as it's inevitably causing more problems than it's solving.