2. speakers
  3. 1256350305

Gallo Reference III midrange COOKED

They were purchased new from a dealer in 2007. I'm using an all PS Audio system (except for a Denon multi-player for a transport). I Was using a p300 power plant till about a month ago I purchased a Power Plant Premier here at Audiogon. Two weeks later the midrange drivers in both speakers are gone. They have since been to the factory for repair and returned. Repair wasn't covered by warranty. They said if the speaker was defective it would have already blown during the first three months.

My system:

Trio P200 pre amp

Digital Link III D/A converter (with Cullen Circuits level 3 mod)

GCA 250 Power amp

Power Plant Premier

The speakers are rated a 350 watts; but my PS Audio 250 watt amp cooked the midrange drivers in both speakers. Go figure...

Just wondering if anyone else out there may have had the same or similar problem?
128x128be_godwin
vandermeulen
191 posts
 
Dump them. I really do not like to give drastic opinions, but ANY "high end" manufacturer who does not make you feel satisfied with how they support their products, should be put out of business regardless of how "good" their product is. It disgusts me really.
elevick
2,638 posts
 
I was always taught this: 1 watt of distortion can do much more damage than 500 clean watts. 350 means little if the system or music aren't perfect.
shadorne's avatar
Ag insider logo xs@2x
shadorne
7,477 posts
 

The speakers are rated a 350 watts; but my PS Audio 250 watt amp cooked the midrange drivers in both speakers. Go figure...

I don't think these speakers are designed to play loud despite their "rating".

The 4 inch mid range is crossed over at 150 Hz to the bass woofer - that is quite low for such a small driver. Also the voice coil is 4 layers - so it certainly isn't designed for good heat dissipation (voice coils get extremely hot when driven hard and can melt or short). It is very likely you simply cooked them.

I suggest to be careful with the volume settings...
audiokinesis
2,748 posts
 
A 250 watt amp driven into mild clipping could easily heat the voice coil more than 350 watts peak of clean music signal.

What Elevick was told is however an exaggeration. It is heat, not a clipped waveform per se, that is damaging. From a thermal power handing standpoing, a clipped waveform simply means the average wattage (heat) going into the voice coil is much closer to the maximum wattage that the amp can put out. 500 watts peak unclipped might be ballpark 50 watts average (depends on the music of course), which is far higher than 1 watt clipped.
martykl
3,578 posts
 
Duke,

I think Elevick was probably told that a higher power amp is less likely to clip in the first place. This advice is sometimes offered to shoppers who will state their amp's power and try to infer a speaker match from their rated power handling specs - kinda like the OP here. I agree that this point wasn't accurately reflected in his post, but it goes to the real issue here: 'twas probably clipping (not too much power, per se) that killed his beasts.

Marty

Marty
More to discover