2. speakers
  3. 1256350305

Gallo Reference III midrange COOKED

They were purchased new from a dealer in 2007. I'm using an all PS Audio system (except for a Denon multi-player for a transport). I Was using a p300 power plant till about a month ago I purchased a Power Plant Premier here at Audiogon. Two weeks later the midrange drivers in both speakers are gone. They have since been to the factory for repair and returned. Repair wasn't covered by warranty. They said if the speaker was defective it would have already blown during the first three months.

My system:

Trio P200 pre amp

Digital Link III D/A converter (with Cullen Circuits level 3 mod)

GCA 250 Power amp

Power Plant Premier

The speakers are rated a 350 watts; but my PS Audio 250 watt amp cooked the midrange drivers in both speakers. Go figure...

Just wondering if anyone else out there may have had the same or similar problem?
128x128be_godwin
chazzbo
1,007 posts
 
Could have just been a stray shot of DC.I mention it because a PS Delta 100 cooked a $4500 set of dual 5.25 mids on some $4500 horns.
2 years is a bit long for extending warranty but then again Anthony Gallo isn't the nicest or dependable guy in Hifi.I have have heard stories and gave up my Gallo Ref 2's as within a year or two of going out production if you blew your tweeters they had not stock to replace them.That's crappy back up and why I am loathe to by another Gallo product.
Good luck.Even though my PS was 20 years older than yours I would have the power amp checked if os epak with PS or independent tech about what happened.
G'Luck
Chazz
vandermeulen
191 posts
 
Dump them. I really do not like to give drastic opinions, but ANY "high end" manufacturer who does not make you feel satisfied with how they support their products, should be put out of business regardless of how "good" their product is. It disgusts me really.
elevick
2,636 posts
 
I was always taught this: 1 watt of distortion can do much more damage than 500 clean watts. 350 means little if the system or music aren't perfect.
shadorne's avatar
Ag insider logo xs@2x
shadorne
7,467 posts
 

The speakers are rated a 350 watts; but my PS Audio 250 watt amp cooked the midrange drivers in both speakers. Go figure...

I don't think these speakers are designed to play loud despite their "rating".

The 4 inch mid range is crossed over at 150 Hz to the bass woofer - that is quite low for such a small driver. Also the voice coil is 4 layers - so it certainly isn't designed for good heat dissipation (voice coils get extremely hot when driven hard and can melt or short). It is very likely you simply cooked them.

I suggest to be careful with the volume settings...
audiokinesis
2,732 posts
 
A 250 watt amp driven into mild clipping could easily heat the voice coil more than 350 watts peak of clean music signal.

What Elevick was told is however an exaggeration. It is heat, not a clipped waveform per se, that is damaging. From a thermal power handing standpoing, a clipped waveform simply means the average wattage (heat) going into the voice coil is much closer to the maximum wattage that the amp can put out. 500 watts peak unclipped might be ballpark 50 watts average (depends on the music of course), which is far higher than 1 watt clipped.
More to discover