Speaker jumpers and hook up choices Question

From Audioquest Note they say to put the pos to the high and neg to the low
When using a single set of full range cables with a BiWirable speaker, you
might as well do it properly … it costs nothing and makes a difference you
can hear. When using jumpers (factory supplied or replacements), be sure
to put both red and black connectors to the treble input of a 3-way or panelhybrid
. Bass is less sensitive to having the jumpers in the signal path.
For 2-way speakers, be sure to put the red connector to treble + and black
connector to bass -. This is the only way to preserve the tonal voice the
speaker designer intended.
If you do not BiWire, at the very least, connect a single set of speaker cables
as recommended above. Ideally, you should use a set of AQ PSC Jumpers
to make the BiWire jumper connections at the speaker. What about those
“free” shiny metal jumpers that came with the speaker? It’s entirely
accurate to describe these as “worth every penny you paid for them.”
Simply put, these are very poor sounding devices.

FWIW - I had been using the AudioQuest diagonal configuration Geph0007 describes above. After reading through the posts on the related bi-wire survey thread that MoFi started (this includes a link to the Nordost single wire for bi-wireable speaker recommendations as transcribed above, again by Geph) I reversed to the Nordost diagonal configuration. My jumpers are from Paul Laudati of Clear Day and non-directional as best I can tell. At any rate, they stayed as they were. I did think in my system, switching go the Nordost arrangement (positive to low frequency and negative to upper frequency post) resulted in a slightly clearer presentation. Tonally the AudioQuest arrangement seems "warmer" but maybe at the expense of clarity (provided by the Nordost method). Of course, in 6 months when I forget what I did today, I'll switch back to the Audioquest approach and swear things sound better.

BINGO that is exactly what I found. I mean you could not have said it better Notice I did not say one was beter then the other.just different Not sure which I like

Geph - good...maybe I'm not delusional. I just went back to the AQ arrangement. The differences (assuming I'm not imagining things) are pretty subtle and seem most noticeable in the first seconds of listening. It's an easy enough switch to make so I'll probably continue to mess with things. Play one track a few times listening to just a few measures back and forth.

Before I hit submit for the above, went back and forth a few times on an AA Bondy track (#2 from American Hearts) on Spotify. Definitely think tonal balance shifts a bit between the two configurations. I'd say bass is a little fuller with the AQ diagonal arrangement. Again it's subtle and I'm not sure how much is placebo (though I kind of lost track of which arrangement was from which company). Not sure I could pick it out in a double-blind test. But maybe....