I should just take off the back plate and tie the high and low together
From Nordost
Wiring Confi gurations
The correct wiring confi guration for a bi-wiring arrangement can be
readily established by experimentation, but in general, the best results
will be obtained as follows:
Connect the jumpers from the bass/mid terminals to the treble terminals,
following the guidance outlined above. Then connect the speaker wires
to the bass/mid terminals. This should be your default set up, generally
offering the greatest rhythmic integrity and mid-band clarity
Very occasionally the reverse arrangement, connecting to the treble
terminals can produce superior results. This is rare, but worth trying,
especially where exotic or hard to drive tweeters are employed
Often, the very best results are achieved using a diagonal connection.
This involves connecting the red cable to the bass/mid terminal and
the black to the treble, with the jumpers arranged accordingly, bass to
treble on the red (or +ve) side of the crossover, treble to bass on the
black (or -ve) side. This is slightly more confusing to wire, however, with
a little extra care and patience the results can be well worthwhile, and
once you are familiar with bi-wiring procedures this often becomes the
new default set up, offering greater air, transparency, dimensionality and subtlety
From Nordost
Wiring Confi gurations
The correct wiring confi guration for a bi-wiring arrangement can be
readily established by experimentation, but in general, the best results
will be obtained as follows:
Connect the jumpers from the bass/mid terminals to the treble terminals,
following the guidance outlined above. Then connect the speaker wires
to the bass/mid terminals. This should be your default set up, generally
offering the greatest rhythmic integrity and mid-band clarity
Very occasionally the reverse arrangement, connecting to the treble
terminals can produce superior results. This is rare, but worth trying,
especially where exotic or hard to drive tweeters are employed
Often, the very best results are achieved using a diagonal connection.
This involves connecting the red cable to the bass/mid terminal and
the black to the treble, with the jumpers arranged accordingly, bass to
treble on the red (or +ve) side of the crossover, treble to bass on the
black (or -ve) side. This is slightly more confusing to wire, however, with
a little extra care and patience the results can be well worthwhile, and
once you are familiar with bi-wiring procedures this often becomes the
new default set up, offering greater air, transparency, dimensionality and subtlety