Do I need a pre-amp?


Major noob here. Researching my first turntable purchase. One potential problem is my existing receiver, Marantz SR4001. Not sure if this home-theater receiver is immediately compatible or whether I will need an additional phono pre-amp? Here is spec book: http://newmedia.engl.iastate.edu/tutorials/DFU_SR4001_SR5001_Final_eng.pdf

Looks like there is a pre-amp OUT but I don't see any phono IN. Maybe that doesn't matter, but I'm not sure bc I don't know very much about this stuff. If I need a pre-amp, how much should I expect to spend to be on par w my entry-level B&W floor-standing speakers? I also have a B&W sub that I would like to keep thumping and will changing my setup require altering that config?

Also, this is the turntable I'm considering: https://app.audiogon.com/listings/turntables-conrad-johnson-sonographe-sg-3-with-alphason-opal-sumiko-andante-turntable-tonear-2015-10-12-analog-02461-newton-highlands-ma Is this a good starter table and on par w my setup?

Thanks in advance for helping me learn and sorry for the scattered questions. I've heard great things about this forum.
lionsdwarf
From what I see you will need at least an external phono stage for this receiver, which you could run into one of the analog inputs. You cannot just run the turntable into the unit, it needs to have the RIAA equalization of a phono stage. No need to go overboard on your phono stage, there are a lot of inexpensive units out there that members can recommend (I got my son a Creek unit to use with his A/V receiver) that will do the job for you.

The Sonograph is an older table (in its day it was a good starter table) but I think, as long as it's in good working condition, it will work just fine for your purposes at this point.
Rcprince is correct. You need a phono preamp and your Marantz doesn't have one. Since you're new, I would just buy all 3 as a package from a dealer that's good with TT's.
Lion

Not mentioned is you need a preamp for a moving magnet cartridge, not moving coil (you will run into both when looking for phono preamps). If you buy the setup in your link.

Moving magnet cartridges (the device that plays the record, mounted in the end of the tonearm) generally put out higher voltages (nominally 3-5 milli-volts or .003-.005 volts at 1 KHz) and are therefore able to use phono preamps that are a bit cheaper.

Moving coil cartridges generally put out a lot lower voltage (a factor of 0.1 or 10% of the MM) and therefore need a much lower noise (ergo more expensive) phono preamp.

Some phono preamps can handle both MM and MC cartridges.

Moving magnet cartridges are sensitive to cable capacitance so you should be aware of this when you buy a phono preamp, as its input capacitance adds to the cable capacitance (of the cables from the cartridge through the tonearm to the phono preamp) to "load" the cartridge. The cartridge manufacturer will specify the recommended load capacitance. If you are too far from recommended ranges, the sound may be affected.

Now, aren't you glad you are getting into vinyl?
I have owned a SG-3 since 1983. It was a great starter turntable then and if in good condition still today. As stated above, you will need a phonostage. I would stick to the moving magnet type cartridge as there are greater choices in carts and stages within your budget. Good luck in your search.