2. amps-preamps
  3. 1448317474

Synergistic Red Fuse ...

I installed a SR RED Quantum fuse in my ARC REF-3 preamp a few days ago, replacing an older high end fuse. Uhh ... for a hundred bucks, this little baby is well worth the cost. There was an immediate improvement upon installation, but now that its broken in (yes, no kidding), its quite remarkable. A tightening of the focus, a more solid image, and most important of all for my tastes, a deeper appreciation for the organic sound of the instruments. Damn! ... cellos sound great! Much improved attack on pianos. More humanistic on vocals. Bowed bass goes down forever. Next move? .... I'm doing the entire system with these fuses. One at a time though just to gauge the improvement in each piece of equipment. The REF-75se comes next. I'll report the results as the progression takes place. Stay tuned ...

Any comments from anyone else who has tried these fuses?
128x128oregonpapa
charles1dad's avatar
charles1dad
10,250 posts
 
Hi David,
I bet your system  with those pieces sounds marvelous. I wouldn't be surprised if  the upgraded  fuses have more impact on the source  (DAC,Phono stage) and preamp than the power amplifier. I ordered  the wrong  size fuses for my DAC (my error ). So I'm  looking forward to the fuse effect on the  DAC once they arrive. .
Charles,
audiolabyrinth's avatar
audiolabyrinth
4,555 posts
 
Thankyou macdude for your reply post. 
snopro
395 posts
 
Hi Charles,
What size Red fuses did you use for the Franks?

Joe
charles1dad's avatar
charles1dad
10,250 posts
 
Hi Joe,
My older Frankenstein MK II ( bought new in 2009) uses one 3 amp slo blo(that plugs into the rear of the amplifier). The SR Red is 3.15 amp(closest match). Your Franks are a newer version so you may or may not have the same size fuse. Joe; the SR Red fuse actually made more of an impact than changing the stock input coupling capacitor(Solens) to the Jupiter copper foil (which was itself a worthwhile change). Just to give you an idea of the sonic effect in my system. Once the fuse burns in for a few days reverse the direction and see which placement sounds better to you.
Charles,
davidpritchard's avatar
davidpritchard
866 posts
 
I am not sure where the most efficatious location is for fuse upgrades except to first replace the main fuse of each piece of equipment in the audio chain. I first started with the amp fuse and worked my way "upstream". Even a subwoofer benefits.

Charles1- I did the same thing with my DAC. I ordered the wrong fuses. The great thing with the Synergistic Research dealer organization was the fuse was exchanged for the correct value with no hassle.

Interestingly  to me is the Antelope DAC uses a fuse on both the hot and neutral circuits. It also has its own separate power supply. The "RED" fuses still made a big sonic difference. So despite a very expensive DAC manufacturer ( Antelope) going to the Nth degree for sonic clarity, changing the fuses to  Synergistic Research "RED" made a big improvement.

After putting in a fuse, I normally wait a week of use before changing the fuse direction. I have not heard as big a difference in fuse direction as TGB forum member has. Meaning the new "RED" fuse sounds better in either direction as compared to the stock fuse.
More to discover