What cartridge on your VPI prime?

@ekimg, thanks for the tip, but my bag had different hardware. I had two sets of screws, both of which were too short, and no sets that were too long. I did wind up ordering the proper hardware, so I have the Ortofon Cadenza Bronze mounted now.

I also just picked up a Transfiguration Phoenix S today, that I will try sometime within the next couple of weeks.
My Prime dustcover just arrived today too!

Anyone else heard anything about VPI releasing a Prime Signature turntable?

Owners of the 3D arm should note that the arm is so good that although Denon, Audiotechnica, etc cartridges that perform in the top of their class, a really good cartridge will give that extra pleasure for years.  Top Lyras, Benz, Ortofon cartridges are the tops in every class.

Glad you got it installed. After installing it yesterday it sounded pretty good for my first install. But today it seems pretty "fuzzy."  I relooked at VTF (2.75) and played with VTA some and even changed loading (200, 100, and 50) but just doesn't seem clear?  Any thoughts?

First install? What protractor are you using? Feickert? MintLP?

I'm running mine at 2.4g VTF and a effective input impedance of 118 ohms into a Bob's Devices Cinemag 1131 SUT. I used a Feickert protractor and set it up using the Baerwald curve. It sounds pretty damn good to me.

Did you check your azimuth? Did you buy it new or used?

http://www.theabsolutesound.com/articles/setting-up-a-phono-cartridge/

I used the VPI jig. I have a Mint ordered. Still sounding "fuzzy" so will continue to tweak today. I have it set at 100 ohms into a Manley Chinook and adjusted the azimuth various times?  Are you using anti-skate. I tend not to but I hooked that up and seemed to help but not alleviate the issue. Yea this is my first attempt so I have a lot to learn. Bought it here on Audiogon...used. Reported to have only about 10 hours use so could it be because it still needs break in?  Everything looked fine.