2. amps-preamps
  3. 1448317474

Synergistic Red Fuse ...

I installed a SR RED Quantum fuse in my ARC REF-3 preamp a few days ago, replacing an older high end fuse. Uhh ... for a hundred bucks, this little baby is well worth the cost. There was an immediate improvement upon installation, but now that its broken in (yes, no kidding), its quite remarkable. A tightening of the focus, a more solid image, and most important of all for my tastes, a deeper appreciation for the organic sound of the instruments. Damn! ... cellos sound great! Much improved attack on pianos. More humanistic on vocals. Bowed bass goes down forever. Next move? .... I'm doing the entire system with these fuses. One at a time though just to gauge the improvement in each piece of equipment. The REF-75se comes next. I'll report the results as the progression takes place. Stay tuned ...

Any comments from anyone else who has tried these fuses?
128x128oregonpapa
mapman's avatar
mapman
22,454 posts
 
Oregonpapa,

Red quantum fuse just arrived. Nice looking fuse, nicely packaged in original box. Seems to have some weight to it compared to most fuses as I remember. Thanks!

I will take it home with me today and see what happens. Might get to try it out tonight in my Audio Research sp16 pre-amp if all goes well.

Hang on to your hats.....
audiolover718
132 posts
 
Oh by the way- for those of you really want to take the fuses to the next level-
if you are using them in a barrel type connector with a spring loaded mechanism, you will notice that there is play inside the connector. Wrap the fuse in Teflon plumbers tape  to make it snug (not too snug to keep the spring from compressing). Don't cover the black dot on the black fuse.  Reinsert and behold even greater clarity and focus. This tweak works on any fuse. Try it and report back. You should like what you hear!!!  IEC's respond well too to this. Minimizing vibrations goes a long way. 
mapman's avatar
mapman
22,454 posts
 
Hmm, Ok issue # 1 for me with this fuse may be a show stopper in that it appears to not match my ARC pre-amp fuse specs.

ARC sp 16 manual indicates it takes a 3A, 230V  slo blow fuse.

Syn. Red fuse is T 3.15A, 500V.

T indicates slo blow I believe (check), 3.15 A is close enough, but 500V rating means this fuse will take slightly more than twice as many amps/power to blow as it should with properly rated 230V equivalent fuse.

Unless I'm missing something I cannot put this into my ARC sp16 without risking damage.


almarg's avatar
Ag insider logo xs@2x
almarg
9,670 posts
 
None of those things are a problem, Mapman. See the post I submitted earlier today, at the bottom of the previous page.

Best regards,
-- Al

mapman's avatar
mapman
22,454 posts
 
Al,

Are you saying the 500V rating is safe even though it is twice what the vendor specifies because such an event /surge can never happen?

Also I’m wondering if the 500V rating alone compared to most fuses rated for US standard voltage at 120 volts might alone account for some sound difference in some cases. I don’t see many other commonly used fuses rated for 500 volts when countries in fact go no more than 230 volts or so. What would be the rational for a 500V rating in this case?

Here is a list of voltage standards per country I found.  Nothing near 500 V.

http://www.school-for-champions.com/science/ac_world_volt_freq_list.htm#.Vub7Ok_nQvY


More to discover