Threshold 400A Amplifier and Conrad Jonson MF2500A

There are two sides to that question. IMHO turning it on and off is worse than leaving it on all the time, but some others will argue with that.  The in-rush of current, stresses the internal components when the piece of gear is turned on and off, (unless the equipment has a "slow start" circuit).

Class A amps do run hot and depending on where you live and the season, they can sometimes force you out of the room. Also, if electricity is expensive where you live, that’s another concern.

Over my many years in the audio biz, I’ve found that leaving SOLID STATE gear on all the time, stabilizes and reduces wear and tear and makes them last longer.

With tube gear, I always turn it off to keep from replacing tubes so often, which can be expensive depending on the type of tube.

Maybe Al, (Almarg) will chime in on this subject. He’s our resident electrical expert and I’m sure has stated a few times his feelings, but I can’t find any of his comments about this subject right now.

YMMV...

Hi Osirir

IME don't plug the Threshold 400A into any kind of power conditioner. I remember I plugged it into a 1.8Kva Isolation transformer & when I turned the 400A on the isolation transformers started humming even louder. After that it went straight into the wall.

Now I didn't leave it on all the time. Electricity by me is expensive. What I had to do to get the amp sounding right was leaving the amp on for 10-12 hours before a listening session. I would turn it on in the morning before work and when I got home after doing some chores in the evening I would start my listening session then. The music sounded real sweet.

Thanks for your wonderful advice. It makes me feel good to be a member when you get honest and useful  response from beautiful people. Thanks Again. Chears  

osirir just curious why does the title of your post mention the Conrad-johnson MF2500A?

Yes indeed. The CJ 2500a is a fine amplifier!