I drive a pair of Silverline Preludes (supposedly 91db efficiency but measured more like 89 in a Stereophile review…Silverline exaggerates their specs a bit it would seem, including the silly 35 hz bass claims for my speakers…35hz with the Preludes is just silly…I've measured it ) with a "factory upgraded" Jolida 502p that puts out maybe 65 watts or so per side, and it kicks butt. My speaker cable runs are AQ 10' Type 8 that sound amazing, and likely would work at 20 feet if they had to. Great cable. Based on my experience with Jolida I bet the 3502 that appears to replace the 502 in the Jolida lineup is a GREAT amp. The only thing wrong with Jolida is they're relatively inexpensive so amp snobs diss 'em. Meh…(my 502 has been abused daily for years and works like new…I've compared it to much more expensive stuff and it shames some well regarded amps that cost 5 times as much). Over the last few years I've scored two excellent REL subs on Ebay at different times for around 200 bucks each…from the same era…a Q150e and a Q108e II, and they take up very little space but provide a much more realistic full range sound that I can't imagine not hearing now that I have these things (well, I can imagine it as I sometimes turn 'em off just to see what's what…and turn them back on immediately!). REL 108s show up online fairly often and if you don't have room for one of those you simply have too much furniture.
Confused: Should I Upgrade Cables or Amp first?
I currently have very long runs of Audio Art SC-5 speaker cable (about 20 feet) that, due to WAF issues, are routed through holes in the floor, under the house. I use MIT AVT speaker interfaces, in an attempt to compensate for resistance.
Speakers: Silverline 17.5 monitors. Components: modded Jolida JD100 tube cdp and modded Jolida JD302 tube (EL34) integrated.
I can afford to put $2500 into the system at this point. I could re-route cables through a wall and relocate components into another room, thereby dramatically shortening cable runs to 10-12 feet and enabling bi-wiring. I could also afford to upgrade all cables. OR, I could leave cables alone and upgrade amp.
Which is likely to produce biggest improvement?
Speakers: Silverline 17.5 monitors. Components: modded Jolida JD100 tube cdp and modded Jolida JD302 tube (EL34) integrated.
I can afford to put $2500 into the system at this point. I could re-route cables through a wall and relocate components into another room, thereby dramatically shortening cable runs to 10-12 feet and enabling bi-wiring. I could also afford to upgrade all cables. OR, I could leave cables alone and upgrade amp.
Which is likely to produce biggest improvement?
- ...
- 30 posts total
- 30 posts total