2. amps-preamps
  3. 1448317474

Synergistic Red Fuse ...

I installed a SR RED Quantum fuse in my ARC REF-3 preamp a few days ago, replacing an older high end fuse. Uhh ... for a hundred bucks, this little baby is well worth the cost. There was an immediate improvement upon installation, but now that its broken in (yes, no kidding), its quite remarkable. A tightening of the focus, a more solid image, and most important of all for my tastes, a deeper appreciation for the organic sound of the instruments. Damn! ... cellos sound great! Much improved attack on pianos. More humanistic on vocals. Bowed bass goes down forever. Next move? .... I'm doing the entire system with these fuses. One at a time though just to gauge the improvement in each piece of equipment. The REF-75se comes next. I'll report the results as the progression takes place. Stay tuned ...

Any comments from anyone else who has tried these fuses?
128x128oregonpapa
davidpritchard's avatar
davidpritchard
866 posts
 

Charles1dad:

I continue to enjoy my Ready Set Go 300 B tube amp. I am now comparing the Sophia Electric Carbon Plate 300"s to the Psvane 300  WE tubes. The Sophia have a little more punch to them and the Psvane more air and relaxation. The new Sophia Blue tubes arrived yesterday. Jeffery Catalano at High Water Sound uses these Blue tubes in his $45,000.00 amps!

Of course a Synergistic Research Black will be installed in the amp tonight. Hello increased sonic bliss in  100 hours.

David Pritchard 

oregonpapa's avatar
oregonpapa OP
4,867 posts
 
^^^ Love it, David.  :-)
 
I can imagine the naysayers being in the middle of a conniption fit right about now. :-)

With the resolution level being attained by many of those posting here, its becoming mind boggling how the slightest changes can affect the sound for the better or for the worse.  One little HFT falling off the ceiling location can be heard immediately. Same for the location of the tube dampening rings. And then there's the switch of one SR Red fuse being replaced by an SR Black fuse. 

In the meantime ... we are getting closer to the music as we follow the tweak and upgrade path. 
nonoise's avatar
nonoise
10,907 posts
 
I don't get it. Either try the fuses yourself or be quiet. One needn't spend a fortune on them to find out. Right now you can get your butts over to ebay and get some PADIS fuses (German made, silver or rhodium end caps, silver wire, ceramic fuses) for about $25 apiece. They're OEM for Furutech at about half the cost, if not more. 

It would be an easy and cheap way to find out if there is anything to these fuses and if convinced, you can splurge on the more expensive SR fuses and see if the improvement justifies the extra costs.

The PADIS have received very positive reviews as well and considering no one here probably works and shills for them, one can trust the feedback, be it good or bad.

No biggie. 

All the best,
Nonoise
oregonpapa's avatar
oregonpapa OP
4,867 posts
 
^^^ Even less cost would be to try the SR Black fuses on the money back guarantee. If anyone doesn't like the results, or think they do nothing for their system, the return postage is what ... 6 bucks?  Oops! There I go a-shilling again. :-)

sherod
1,690 posts
 
Oregonpapa,

      You are going to love the Von Gaylord interconnects. I have a mix of Chinchilla and 7000s throughout my system, even in my bedroom system and they are the best I've ever had and I've tried a slew of them from many manufacturers. Please make sure you get at least 200 hours or so on them before you fully evaluate.
More to discover