The merry go round. $700 seperates or integrated?


  If I have $700 to $800  to spend at most  am I better off with a used integrated say Marantz PM 15S1 or Anthem 225 as examples or do I go for the NAD/ Rotel/Adcom/Parasound  used preamp power combos.  I want phono remote and a headphone jack.   I am taking about sound quality here and not  power but would like to stay above 80w/ch  I have always preferred an  integrated amp has there is less screwing around with power cord and IC choices which just are more variables but for less then the amount listed above one came up with some nice combo pre power set ups. The speakers are Infinity RS 2.5s.   FYI I worked in the audio biz and helped countless people do this but I think I am in mid life crisis and have heard/ compared  to much gear in the last few years.  I  can hear differences pretty easily  and find much mid gear today to be thin, over detailed and unmusical.  I even tried one integrated I swear screwed up the timing of the music. I find most older gear swings but no remotes. Something like an old Luxman R117 receiver which I had last year was sure fun  Not perfect but very enjoyable.  it have had remote.   Just want to get off the merry go round.Thanks
128x128geph0007
I agree with yogiboy, go for the Sphinx. I've owned 2 and they are the best I heard at that price point. If you had to drop an extra $100.00, well worth it. Made in the USA as well!
Thanks guys.  I thought about the Rogue also but here is the issue  Lets say  the Rogue used runs $800.  For less then that  I can pick up a MOS FET Adcom GFA 5500 for $300 and then find say a Adcom GFP 710 or 715 for $200-$250  Same could be said of NAD or even some Parasound stuff.  That is the issue.
I am familiar with the RS 2.5 and other Infinity speakers from that time, and I think it needs a very powerful amp. Infinity recommended a minimum of 100 watts, and that should be a very high current amp. Being a 4 ohm speaker dropping much lower and the type of drivers used means this speaker will be a very demanding load on the amp. It would be best for the amp to double power into 4 ohms or at least get somewhat close to a double. I seriously doubt that many of the amps listed in this discussion could adequately drive that speaker. Not meaning that anything is wrong with those amps, they just don’t have enough power. Like putting a Toyota Tacoma 4 cylinder engine in a Hummer H2 resulting in much less overall  performance of the Hummer and it being capable of more.

The issue is not integrated or separates, but making sure the amp has adequate power to drive and control the speaker.