Class A multichannel amplifier?

Due to what Roscoeiii describes, I found the best alternative for my Coincident theater. I'm using a Mac 7106 which is 100 x 6. Mac is clean, crisp, detailed and a little on the warm side. Since I only need 5 channels, I bridged 2 channels to give extra power to the center. Conquest R&L, Triumph center, mini Triumph rears. The only other amp I would consider for this theater in my price range is the Cary.

Allchemie, you heed a multichannel preamp, NOT a pre/pro, for your expensive system. I have and love a c-j MET1; McCormack and others also make them. With an analog preamp, the player does all the decoding and bass management and you use the player's analog outputs to the preamp.
.

I realize that a Class A multichannel amp would put out a lot of heat. Maybe I should consider a Class A/B with high bias into Class A. I heave heard that Earthquake Cinenova makes one that can be biased up to 20 watts into Class A.

I also wonder if the Arcam multichannel amp is biased highly into Class A, such as their AVR600 is. I have heard that the AVR600 is also biased to about 20 watts into Class A and that is what gives it its great sound. One would hope that Arcam would have put that same technology into their new multichannel technology, but I see nothing to that effect on their site.

When the OPPO BDP95 comes out in March I might purchase it and move my OPPO BDP93 into my bedroom system.

Is the Integra DHC 80.2 processor considered good? Or would it be smarter to get an Anthem or a Classe processor. Also, are the Classe multichannel amps good?

Greg

Classe' amplification products are generally considered higher end than the others on your short list. Classe' room EQ adjustability may require a different process which you should check into.

Unless your attempting to assemble a high quality two or multi channel system that will also support HT then quality amplification components may be considered critical by some. If, on the other hand your assembling a primarily HT system the level of quality amplification may not be as critical.

Personally, in a primarily HT system I would forgo some quality in favor of a 7.1 HDMI system. Depending on your viewing habits an HT system can be in use far more that a music only system which would demand far more running time from an amplifier. High quality switching amplifiers are far more efficient for this purpose requiring less wattage, less in standby, less heat, and more economical.

The Arcam AVR600 is a class G amplifier.

Class G
The Class G topology is a modification of another
Class of amplifier (normally Class B or Class AB)
to increase efficiency and reduce power dissipation.
Class G takes advantage of the fact that musical and
voice signals have a high crest factor with most of
the signal content at lower amplitudes. The Class
G topology uses multiple power supplies, operating
from the power rail that provides the optimum
combination of headroom and power dissipation.
Th e Class G topology improves amplifier efficiency
by optimizing the power supply. A Class G device
uses a minimum of two different supply rails. Th e
device operates from the lower supply until output
headroom becomes an issue. At this point the device
switches the output stage to the higher supply
rail. Once the output signal drops below a predetermined
level, the device switches back to the
lower rail. Power dissipation is greatly reduced for
typical musical or voice sources. Figure 3 illustrates
a simplified Class G implementation with a split
supply Class AB output stage.

I am currently using an AVR600 in my home system and have nothing but praise for it. Outstanding sound superior to most anything else I have heard for HT including Classe` and other high end HT receivers.

In 2 channel mode using Dali helicon line of speakers it sounds remarkably good. Although it is difficult to set up a system that sounds good for both HT and 2 channel. This will be a challenge especially with a projector you will need a retractable screen for 2 channel. So unless you need one system to do both which I recommend against I would think the need for Class A amps in a HT are not necessary.

The need for 7.1 seems to be overrated since so few BD discs are actual 7.1 and 95% of the time you will be listening in 5.1 EX. I have to admit there is a huge difference between the 2 and if more discs were supplied in 7.1 I would say spend the extra on the speakers . For now you might consider wiring your room for 7.1 and seeing what happens in the future of these discs if more 7.1 content is released.