2. home-theater
  3. 1323786801

System shutting down due to clipping?

From time to time my HT system shuts off when playing at higher volumes. The Yamaha AV unit is running out of juice and I assume it is tripping off as a self preservation function. I am guessing that the rear surround speakers are the culprits since they are 4 ohm. I am not sure whatload the center channel is.
SO how do I fix this? I do not want to change the AV unit and am not real keen about changing the speakers either. Don't even think of suggesting that I turn the volume down.
128x128blueskiespbd
blueskiespbd's avatar
blueskiespbd OP
161 posts
 
I checked the manual and this newer model AVR does not have a 6 ohm option. The surrounds are set to small and I did dial back on the master max volume setting.
I am not going to replace the AVR since it is fairly new. I will consider changing out the speakers if I cannot get this fixed. I do not want to "turn it down" since the system needs to play at the volume level I want. It is suppose to please me and I am not going to play at a low volume in fear of the system shutting down. If the problem is overheating as Elizabeth suggests then a fan should certainly help. I just have to figure out how to wire one into the system. More testing tonight. And no I wasn't playing it on 11.
rockvirgo
587 posts
 
Put some more 4 Ohm speakers on that Yamaha, crank it up and show it who's boss.
tbromgard
814 posts
 
Make sure you have good ventalation or a fan as suggested. This is most likely a heat problem.
tls49's avatar
tls49
1,351 posts
 

Blueskiespbd, check your manual again, page 20. There is a 6 ohm option, if your receiver is the RX-A1000.
chadnliz
3,736 posts
 
I doubt its heat but goid luck all the same.
More to discover