Technics Sp-10 platter screws

Hmm. My recently purchased SP10mkII has screws(original I think) but without washers. Should I get washers to put between the screws and the platter?
You guys are always costing me money ;-) Cheers,
Spencer

Never seen washers on the platter screws for a MKII or MK2A.  Service manual diagrams and parts lists don't call them out, and my NOS MK2A that doesn't have any in the factory sealed hardware bag. 

Thanks, JP. Happy to see your participation here. Cheers,
Spencer

I've had four of the MK2 come through here and all of them have had washers / bushings under the three screws that hold the platter to the motor. so I don't know what you are talking about - will post pictures on my systems page later today.

Good Listening


Peter 

Peter, Before reading your post, I would have agreed with JP, but the sum total of my personal experience with the Mk2 is equal to 2 samples (one each of a Mk2 and a Mk2A).  Neither had washers under the platter screws, unless you are using the term "washer" to describe the cylindrical unthreaded area just under the head of the screw.  Anyway, I suppose a thin washer could do no harm, either way, so long as the head of the screw does not protrude above the level of the platter surface.