Dielectric grease on connection ends


I was changing a coil on one of my bikes earlier, and as always, applied a light film of dielectric grease on the coil outputs, and on the spark plug boots. A thought occurred to me that this may be a valid application in audio connections as well. A small amount applied with a cotton swab to bananas/spades/rca's etc. may help, and I'm thinking about giving it a go. Was wondering if this has been tried by any other members, and thoughts on the pro/con aspects.
128x128crazyeddy
As a word of warning, the DeOxit in the red spray can is about as much as you want to use when dealing with connectors!

This is especially true of tube sockets!!

What can happen is the material can creep and contaminate connections, with the result of loss of performance (especially at higher frequencies). So its best just to clean the connections and then **leave nothing on them**! If a contact enhancer gets on insulators (like are found in audio connections) its usually not good.

So while a dielectric grease can inhibit connections, contact enhancers can short them out. I've seen people ruin equipment by indiscriminate use; be careful!!
Hey Eddy - Try Parts Express.  See link here for a range of Deoxit products including Gold in bottle with brush and spray can.  A bit cheaper than $200 per ounce, it would seem.

http://www.parts-express.com/Search.aspx?keyword=deoxit&sitesearch=true 





Thanks Dave and Ralph. I think, after what I've been hearing, is that I will do without, and occasional use a little contact cleaner, and go without any coating whatsoever.

Thanks for all the comments folks.

By the way, unlike a lot of oxides, copper oxide is just as conductive as copper. :)

Of course, I still use crimp bands and nice speaker connectors anyway.

Best,

Erik
" Any suggestions. I have tried ordering other products from the US before (liquids) and always have been denied, due to cross-border restrictions on shipping liquids"

Freeze it before shipment.