you took my statement out of context. Here is what I actually said:
Yes- it was not to contradict you, but to use the phrase as a talking point, as I see that approach recommended a lot. Then later people sell off the gear in search of that holy grail... I think if you start with the grail first you're less likely to sell and waste the cash.
Atmashere, the OP said nothing of ESL's. I did make mention of : "Most typical speakers...."
Correct- in fact by 'most typical' is about 95% of the market. In high end, its still about 85% and so is 'mostly accurate' :)
For those outside of that percentage (Charlesdad's speakers are box speakers but they are an example) that voltage thing just does not work. This is entirely due to the designer wanting the speaker to work with a particular kind of amp. In Charlesdad's case, the speakers were originally envisioned on a set of our M-60s and later that manufacturer started making SETs, which work much the same way. SETs in general are much happier on higher impedance loads despite often having 4 ohm taps and they tend to make constant power rather than constant voltage owing to zero loop feedback.
In a tube amp, the 4 ohm tap is not an efficient way to use the output transformer, which often means not only less power (lost due to heat) but also less bandwidth, sometimes up to an octave lost on the bottom end. So its often really worthwhile to avoid low impedance speakers with tube amps even if you have the taps on the output transformer!
