speaker shopping


I have a classe fifteen amp with parasound front end and am looking for speakers to go into a 12x22 room with 4 ft knee walls.
cwright590
Hi cwright590, Thanks for the info, I took a look at these drivers. The good news is that the tweeter has a better impedance curve than most. The bad news is that both drivers need to be notched. and you would need some steep slopes and the woofer need Z-comp..  In the end, it could be very good, but it requires some crossover work. If you'd like, your welcome to pm me.  If not, I understand, I hope this helps, Tim




Timlub  if you wouldnt mind. I will send you my latest crossover diagrams to look at. I am thinking about taking out the 1 ohm resistor on the tweeter to see if that works. Send me your email to cwright590@bellsouth and i will send it to you. Thanks
I'd wait on speakers until you give the Scan Speak a try,  I've looked them over, I'm sure that they are capable a singing....
Here is the basics of what I'd do to these...
I'm not sure if you are running a speaker program or not, but if so, plug this in:
Crossover, 12db L/R on the tweeter @ 2k, impedance at crossover point is 6.3 ohms.  You'll need to notch the tweeter 3db from 2k to 4k...
Ideally, you need a notch filter on the woofer, I worry about what phasing will do by crossing these within the notch without running these on a program, please check that out.  For now, i'd run
24db L/R on the woofer @ 2k, crossover on an impedance of 4.5 ohms,  you'll need zobel on the woofer for that crossover point to work.  You'll still be dealing with a slight peak in the woofer... without notching it, it won't go away.  I'd listen to these with a slight tow in, that will take care of it...
Another option would be to completely notch out the peaks in both drivers and cross between the notch at 4k... my experience says that the option that I laid out above will sound slightly better, but not much and with the 4k crossover, you could use a much simpler crossover approach.  6/12 butterworth with zobel on the woofer only...
I hope that this all makes sense, Tim
"wolf..." - no, I'm not a dealer... I'm a customer - have had the GT's for 3+ years - which is why I know how great they sound.   They sound every bit as good as all of the customers / reviews have reported.  And... it's because its so hard to believe they can sound that good... that motivates me to "tell their story."  It's amazing... quite frankly.