Good Speakers with Pass XA30.5 Power Amp?


I'm currently using a Pass XA30.5 power amp (with Pass XP-10 preamp) to drive a pair of PSB Synchrony One. Cabling is all Wireworld Equinox 7 and room is about 12'(W) x 24'(L) x 12'(H) with speakers firing down the long dimension - although I can only sit about 7' from the plane of the speakers. I find the sound somewhat laid-back, i.e., lacking in liveliness and I'm constantly fussing over the sound of the system. I listen at very moderate levels to a wide variety of music, but typically jazz (vocals), classical and choral music - with the occasional reggae and pop fare.

It's been suggested to me that the combination of the Pass XA30.5 and Synchrony One may not be a good match so I'm soliciting suggestions for speakers that should work better with the Pass amp - i.e., a more lively presentation. I'd prefer full-range speakers at least the equal of the Synchrony One in resolution and frequency extension. My budget is less than $4k used.
partialresponse
Having participated in your previous thread, I’d like to add some facts regarding the Synchrony One. It is a demanding load with an impedance magnitude which stays below 4 ohms throughout the midrange and drops below 3 ohms at several frequencies. Specs; 88dB sensitivity/4 ohms.This speaker performs well with high SS power/current, so I recommended a more efficient and neutral speaker for the Pass’s 30wpc/8 ohms.
I have a Pass Labs XA30.8 and its currently powering my Proac D-30Rs.
They are an easy load for that amp and match well together IMO.


Anyone try original Quads (57s) with the XA30.5? Apparently the XA30.8 is a great match for the Quads according to an online review.

I have a Pass XA 30.5 that I switch out time with a pair of VTL MB 125 tube amps and I love it with my Wilson Sophia 1s, really nice combo and our listening taste and music are similar. 

I'm running an XA30.5 at the moment with a pair of Magico S3's in a 15x24 room and find it to be an excellent match short of trying to reproduce Rave/Rock Concert levels in my room.

I would doubt that your speakers load is much of an issue for this amp since the load of my speakers is significantly more brutal and the amp seems barley phased by them. In fact, I've only seen the needle slightly move when cranking it up to a 92-95db level at my seated position 9ft away.

I typically listen to Rock/Metal/Pop so if there were an issue with its output power or lack thereof driving the S3's I would notice it pretty quickly. So far, I haven't witnessed any problems with it.

With that said though, there is no question that the XA30.5 is known to be a laidback sounding amplifier anyway. If you happen to be using cabling that is also laidback then this perception of its sound could be even more compounded.

I would recommend trying a dead neutral set of XLR Interconnects and Speaker cables from Mogami as an inexpensive test to see if it livens things up a bit for you.