This manual has all the options for any subwoofer hookup!
http://www.psbspeakers.com/content/160419102939-PSB_SubSeries_English_Owners_Guide.pdf
http://www.psbspeakers.com/content/160419102939-PSB_SubSeries_English_Owners_Guide.pdf
Subwoofer cable question for those in the know...
My preamp has an extra set of line level outputs to drive a powered sub.
Would there be any advantage to running separate L/R cables since it is purely a bottom end booster, or can I Y the signal out/signal in and run just one cable between pre and sub?
Also, what is the difference in construction between "subwoofer cables" and ordinary shielded RCA cables?
I haven't seen anything definitive, and I assume they are designed to carry just a low frequency signal better, as opposed to full range signals?
Advice, of course, is greatly appreciated.
- ...
- 10 posts total
| Post removed |
As they only need to relay lower frequencies, sub cables don't need to be as highly configured as regular speaker cables. Even Vandersteen supplies rather ordinary cable with his subs. I use Cable Solutions, as recommended by Almarg. http://www.cs1.net/products/cable_solutions/O2X-Series_12awg_speaker_cables.htm#purchase Without knowing what sub and pre you are using limits what can be recommended. For me, using a powered subs, I use two runs from the amp-one for speakers, and one for the subs if I don't have a crossover. Since both speakers and sub share the same signal, integration should be easier. Bob |
There is a slight difference in running 2 separate cables to the L/R inputs on the subwoofer vs. using a Y adapter at both your preamp and sub. On my system, the 2 separate cables sounded a little better. It's not a big deal and many wouldn't hear any difference at all. I was using a VMPS sub and VMPS ribbon speakers. They have very good definition. |
- 10 posts total