Straightening Bent Fins

After I have lived with the amp for over a week now, I am not quite as upset about the fin as I once was. But I'd still like to fix it, to maintain the value of the piece. And there are 3 heat sink plates per side Jetter, the 300's have 3 per side and the 600's have 4 per side. 

Im not sure, but the heat sinks on the later FPB models may be the same? On the C and Cx models? So perhaps Krell will still have them in stock? Anyway, I've sent an email to Tech Support at Krell to inquire about a new heat sink, I suppose it's a holiday weekend for them, so hoping to hear from them later this week. I was an electronic tech in a previous life, so am confident I can make the swap. 

I would never have taken it.Was it in the original box??

You may be right ebm, I'm sure it affects the value. But the original exterior box was undamaged, and I guess I wasn't up to the hassle of returning it over what seemed like a small thing at the time. But, I love the amp, it sounds amazing, and other than that fin I am very happy with it. If it's the last amp I ever own, then it's accidemic.

I emailed Krell, and have not received a return message. I have the worst luck with manufacturers. Everyone goes on and on about how great Krell is, and they won't even respond to a polite, simple question? I'll call them on the phone, perhaps I'll have better luck. 

Alpha-Gt

Contact Patrick direct through email.   

pbresnahan (at) krellonline (dot) com

If you're in Arizona.....DanD'ag is in Cave Creek....about 1/2 mile from me.