2. amps-preamps
  3. 1448317474

Synergistic Red Fuse ...

I installed a SR RED Quantum fuse in my ARC REF-3 preamp a few days ago, replacing an older high end fuse. Uhh ... for a hundred bucks, this little baby is well worth the cost. There was an immediate improvement upon installation, but now that its broken in (yes, no kidding), its quite remarkable. A tightening of the focus, a more solid image, and most important of all for my tastes, a deeper appreciation for the organic sound of the instruments. Damn! ... cellos sound great! Much improved attack on pianos. More humanistic on vocals. Bowed bass goes down forever. Next move? .... I'm doing the entire system with these fuses. One at a time though just to gauge the improvement in each piece of equipment. The REF-75se comes next. I'll report the results as the progression takes place. Stay tuned ...

Any comments from anyone else who has tried these fuses?
128x128oregonpapa
oregonpapa's avatar
oregonpapa OP
4,867 posts
 
Shadrone sez:

"If a mere fuse makes a huge difference in sound then that should tell you the condition of your equipment is piss poor."

What??!! Are you kidding? Yes, you must be. The higher the resolution afforded by the electronics to begin with, the more the improvement made by the upgraded fuses will be evident. Just the opposite of your claim. 

Frank
mlsstl
1,428 posts
 
in the spirit of this thread, I thought I should warn people to NOT mark directionality on their fuses. The ink or sticker could confuse the electrons, drawing them off-center. The same is true of handling fuses with your bare fingers -- deposited oils from the skin could cause the same problems!
jetter
3,032 posts
 
Its also important to have the fuse installed by a virgin with no impure thoughts.
shadorne's avatar
Ag insider logo xs@2x
shadorne
7,467 posts
 
No I am not kidding. I do not want equipment that magnifies minute variations in the power supplied to the amplifier power supply which is supposed to filter and protect amplifier circuits from power variations. Why would I want to hear differences in fuses or the small effects of my neighbour down the street when they turn on an appliance and the small effect it has on the power my home receives. It makes no sense to build audio gear that magnifies such things - if you hear such things then either the equipment is faulty or the design of the power supply is atrocious.
georgehifi's avatar
georgehifi
10,312 posts
 
Frankmlsstl656 posts03-14-2017 3:21amin the spirit of this thread, I thought I should warn people to NOT mark directionality on their fuses. The ink or sticker could confuse the electrons, drawing them off-center. The same is true of handling fuses with your bare fingers -- deposited oils from the skin could cause the same problems!jetter305 posts03-14-2017 3:49amIts also important to have the fuse installed by a virgin with no impure thoughts.

+1 To all.
"The fuse element must not be damaged by minor harmless surges of current, and must not oxidise or change its behaviour after possibly years of service."
On a serious note, what these guys are hearing is an old fuse changed for a new one as this fuse manufacturer stated, and you don’t have to spend $100, just get another new 10 cent one, and a good idea to clean the fuse clamps.

Cheers George

More to discover