Synergistic Red Fuse ...

shadorne   3/13/17

"  If a mere fuse makes a huge difference in sound then that should tell you the condition of your equipment is piss poor. 

The power supply is supposed to be designed to entirely isolate the interference of slight differences in power input from the audio signal. If a mere fuse makes a difference then pretty much anything will make your setup sound different. A system that can't handle such minute differences will never sound the same from minute to minute, day to day. Power is varying ALL the time - a fact of life given that stuff in your house and street go on and off all day long.

I would immediately get rid of any equipment that was so unstable and inaccurate that minute differences in power input have large effects on what I hear.

Surely it is self evident that we are trying to listen to the source music with the least interference or coloration from extraneous factors and it makes sense to buy equipment that achieves this"

THIS IS THE MOST UNINFORMED POST I HAVE SEEN ON AUDIOGON.  THIS IS ILLITERACY IN ITS MOST RAMPANT FORM. 
It is very disturbing to observe that is guy has made more than 5000 posts on Audiogon. VERY SAD.

Shadrone sez:

"If a mere fuse makes a huge difference in sound then that should tell you the condition of your equipment is piss poor."

What??!! Are you kidding? Yes, you must be. The higher the resolution afforded by the electronics to begin with, the more the improvement made by the upgraded fuses will be evident. Just the opposite of your claim. 

Frank

in the spirit of this thread, I thought I should warn people to NOT mark directionality on their fuses. The ink or sticker could confuse the electrons, drawing them off-center. The same is true of handling fuses with your bare fingers -- deposited oils from the skin could cause the same problems!

Its also important to have the fuse installed by a virgin with no impure thoughts.

No I am not kidding. I do not want equipment that magnifies minute variations in the power supplied to the amplifier power supply which is supposed to filter and protect amplifier circuits from power variations. Why would I want to hear differences in fuses or the small effects of my neighbour down the street when they turn on an appliance and the small effect it has on the power my home receives. It makes no sense to build audio gear that magnifies such things - if you hear such things then either the equipment is faulty or the design of the power supply is atrocious.