Looking at sub $200 power cables.


I’d like to upgrade my power cables if I can see a benefit at the $200ish and under price point in my setup:
-Yamaha 1060 AVR (used as preamp)
-Parasound A23 Halo
-Bluesound Node 2
-Furman 15i PC

I already have some decent interconnects and speaker wire so the power cords are the next place I can tweek. I’ve been reading a lot and it seems I would get my best results starting with my AVR. How important is it to swap the PC out for the Furman to the wall? I’ve been eyeballing some decent deals on Shunyata Venom 3 PCs. I can get 3 of them for around $320. How does the new Shunyata Venom 14 compare?

Is this a waste of money in my system? Should I skip the Node? I understand it’s subjective but appreciate any input.

Thanks.
asahitoro
I noticed a big improvement going to at least a 10ga on my amp, from a 14ga. Others have said it shouldn't make a difference so see if there is a return policy on whatever you buy, in case you don't hear a difference. 

All the best,
Nonoise

i also noticed a big improvement going up to 10 gauge PCs on my amps and power box.  the furman might be best served with the beefiest cord you can afford if everything else is plugged into it.

but fat cords on amps are where it's at.  particularly high power amps.
+1 on the above. IME you should use 10 awg on the amp and from the wall to the Furman. 12 or 14 awg should be fine for your pre and source as they draw low amounts of current. Read up on what people have to say about different brands of cable so that you can determine what properties are important to you and what you need more of or less of in your system to keep it in the proper balance for your listening tastes. As always,... everything matters! your experience may differ from others as we all have different gear and hearing.
Great input, thanks again everyone.

The Pangea AC 9SE is 7ga but it’s about the same price, maybe a little higher, than what I see used/leftover 12ga Venom 3 pop up for from time to time. I think I have my mind made up at least on the AC 14SE for my AVR/preamp, Node 2 (C7) and my display.