2. home-theater
  3. 129123-36302

New Two Zone System - I'm out of my League

Hello,

I've read a ton of the Home Theater posts and everyone is super knowledgeable and helpful.  I'm kindly asking for everyone's advice.

I have always been a two-channel (amp, pre-amp, tower speakers) person.  My wife and I are remodeling our main floor and now the two towers have to go - I'm sure you can guess why!


Zone 1:  In the living room I will have two in-wall speakers - left/right speakers on the sides of the TV and a powered subwoofer.  Unless you suggest otherwise, I'd like to use my existing Parasound amp and pre-amp separates to power the two in-walls and send an audio signal to the powered subwoofer (using "loop output" on the amp).  These speakers will mainly be used for TV watching, and occasional music playing.  I have no interest in anything more than this 2.1 set-up.


Zone 2:  In the kitchen on the same floor as the living room I will have two in-ceiling speakers.  These speakers will play music.  I was thinking I would power these speakers with an integrated amp.


Most times - it will be the TV audio playing through the in walls in Zone 1 and music playing through the in-ceilings in Zone 2 (simultaneously).  This is easily accomplished with the set-up I described above (I believe).  My question / confusion is this - I'd ideally like the option to play music from the same source in the two zones at the same time (same music playing through all four speakers in the two rooms).  Can you please tell me the easiest / best way to accomplish this flexibility?


Thanks in advance for any help you can provide.

Matt

mminor
auxinput
2,921 posts
 

Unfortunately, the only way to get where you want to go is either a full blown Home Theater Processor or a AV Receiver. I don’t know of any 2-channel preamps that will do a "zone 2". The HT Processor or AV Receiver will replace your existing 2-channel preamp and will act as a source selector and volume control for both Zone 1 and Zone 2 speakers. You will need to supply an amplifier for Zone 2 if you choose an HT Processor (an integrated is not needed). Some AV Receivers can use other speaker outputs for Zone 2 (such as the "height speakers"). If you are still interested in this path, give us the following details and we can help guide towards a solution:

- What is your current model preamp/amplifier?

- What is your budget for this HT Processor / AV Receiver?  This also decides the audio quality you will get out of this device.

- Do you have any specific video source requirements such as HDMI, 3D or 4K? Tidal, Netflix, streaming, DLNA?

You’ll have to replace your current preamp. The HT Processor route is the better way to go for sound quality and to keep your current amplifier. However, your budget may force you to do an AV Receiver if you want all the bells and whistles (4K, Netflix, tidal, streaming, etc.).

mminor OP
5 posts
 

Hi AuxInput.  Thanks so much for your detailed and quick response - I really appreciate it.  My more in-depth details are below.


Amp = Parasound HCA-1500A (200 watts per channel, 2 channels)

Pre-Amp = Parasound PLD-2000

$1,000 = Budget for HT Processor / AV Receiver (I'm still not clear on the difference between the HT Processor and AV Reciever)

Video = HDMI 4k / 18GB, Netflix, streaming - I originally was going to run the HDMI directly from the cable TV box to the TV and then run Audio left/right from the TV to the preamp.  I will also have a cat5 cable going to the TV (for streaming).  But I understand the HDMI can carry the audio signal as well, I'm def open to / looking for suggestions here.


I'm fine not using / replacing my current Parasound preamp.  If I use the HT processor or AV Receiver - will I be able to choose which zone I use my current Parasound two-channel amp with (Living Room, in-walls)?


Please let me know if any further info would be useful.  Thanks again for all your help!

Matt



gdnrbob
4,508 posts
 
Perhaps a Bluesound Node for each room, if you get the integrated for the kitchen, connected wirelessly, would allow you to stream music to both rooms.
I use it for my office (2nd floor) and living room (1st floor). It works perfectly. And, it doesn't cost an arm and a leg. 
I am using the Node 1, which I bought on Ebay for around $200 each. 
The Node 2 has a better DAC, so it might be better if you are not planning on using a separate DAC like I do.
B
More to discover