Acurus Act 3 vs Lexicon Processor


Looking for a processor for HT only that I will pass through my preamp into my cary cinema 5 amp. Want 0 noise. Would like to spend $500 or less so the above fit nicely. Opinions?
jamesw20
"Personally, I'd look elsewhere?" Where would you look. Again, I only need the processor for HT, music is handled elsewhere.
At $500? That is tough. The act 3 is a veritable bargain in this price range. But it isn't the quietest in comparison to some. So that's probably out.
I'd probably consider used Thule 5.1 dd/dts piece. The Outlaw 950 is good sounding for the money for certain, but a little shy on dynamics IME.
Actually, dare I say it, but a used receiver from Yamaha makes for a good AV pre/pro for movies. Anyway, seems to be detailed enough (most better than, say, a Classe SSP25), and rather dynamic used as a pre/pro. For cheep some of these more recent pieces are worth a try.
Remember, for $500, you don't have much choice. Still, not bad
If it is only for movies, get a Rotel 1068 and save a bunch of cash, it has great adjustments for each speaker, bass management and individual tone controls for each speaker is IMO a really nove feature.
I know there are alot more expensive units that MAY be better....but if you not anal about a simple movie system the Rotel is a great buy. And the opinion on the Lexicon by the other poster is simply opinion....the Lexicon can and does sound very good, and I have alot of experience with my fathers unit.
If you really want to save a lot of money, and you're doing this only for movies - here are some more thoughts:

The B&K AVP3090 is a steal on the used market at <$300, and somtimes close to $200. It sounds great and is reasonably quiet, although may be suseptible to RFI that requires special attention. You can probably get a Ref 20 for under $500, and Ref 30 maybe for a tad more than $500 depending on condition/age. B&K service and support is the best I've experienced from any company. The 3090 doesn't have optical in, but does support DD and DTS.

I don't have experience with the Rotel 1068, but do with other Rotel pre's and it's been good. They're not bullet-proof like B&K, but they are built nicely, and sound great.

The Sherwood-Newcastle AVP9080r can be had for $200 and is quiet. Setup isn't as user friendly or flexible as the B&K nor the Lexicon DC-1. One strength is it has 5.1 inputs.

I tried several Yamaha receivers before finally going to a separate pre/pro, and amp. Don't waste your time and money on them.

I'm not sure if this is a fair comparison, but I had the Acurus Act 1, which is pro-logic only, and while for the money it was nice, it was very noisy and prone to ground loop. It's also a bit bright. I don't know of these traits are common to the Act 3.

Back to the Lexicon DC-1, I went throuh all of the above, still have the 3090, and the Sherwood, and the DCs is my primary HT processor. I frankly can't relate to the comments made above. The sound quality rivals many pure stereo pre's I've tried, including Rotel RC1070, and also Classe CP35. It has its shortcomings, but I really like the flexibility (7.1 capability) 7.1 inputs, Coax and Optical ins (though only 2 of each), and easy, flexible setup. My use is PRIMARILY music videos in a dedicated home theater, so the music quality is important to me. I generally watch movies upstairs in a less critical environment (ie the family room) using the B&K as a pre-pro.

Finally, since you're talking about used here - I'm sure it's not gotten by you that you can buy one, if you dont like it resell it and move on to the next one.