As this is my first Tube Amp and Preamp, I have no idea who sells these, nor who is a good source. So, where do you guys get these tubes?
Bob
Bob
Amps Atma-Sphere M-60 Mono blocks OTL design
I just purchased a used OTL Atma-Sphere M-60 mono blocks that I have sent to Atma-Sphere to be upgraded to the current model 3.3 and I also added the option of a higher quality power supply and V caps.
I have sold my old trusted Eggleston Andra 2’s speakers and have built some monitors using Aurum Cantus ribbons (102db) and Aurum Cantus midwoofers (90db) that are both rated as 8 ohm nominal. I have a DEQX Premate and will be crossing over to (2) JL Audio F-113 subs at 80hz.
Currently I am using a solid state high power stereo amp (Pass Labs) that I used with the Andra 2’s.
The Atma-Sphere M-60 is rated at 60 watts class A and is said to work better with higher impedance loads.
It will probably be a few weeks until I get the M-60 and was hoping someone could provide opinions of what to expect.
I listen to late 60 early 70’s classic rock music mostly. Sometimes loud.
ozzy
- ...
- 245 posts total
Hi Bob, I’m not sure that even the ancient drugstore-type tube testers some of us remember from our childhoods measured heater-to-cathode leakage. Most of the better professionally oriented testers from those days did, however. (I have a vintage Hickok 800a). For most users I suppose the only practical alternative is to see how the tubes perform in the particular application, and hope for the best. And given the many positive experiences that have been reported with Sophia tubes, including the 6SN7, I suppose the odds of success are good. Although note that in some of the cases I referred to the hum problems didn’t arise until the tubes had been in use for some period of time. And of course I have no way of knowing if the problems that I and a couple of others reported represented atypical examples of the particular tube type, or were due to a combination of tube characteristics that are more typical combined with sensitivity of the particular component designs to those characteristics. Note also that as I said in the thread I linked to Ralph has indicated in the past that he rejects tubes having heater-to-cathode resistances of less than 10 megohms (i.e., 10 million ohms). And for the 8 Sophia 6SN7s that were in my possession (4 originally purchased; 4 replacements provided under the warranty) ... The heater-to-cathode leakage in my Sophia’s, as measured on my vintage Hickok tube tester, was as low as 3 or 4 megohms on some sections of some of the tubes, and was in the 5 to 10 megohm area on most of the others.FWIW, I personally don’t envision Sophia tubes as being in my future, despite all of the glowing praise they have received from others. Best regards, -- Al |
- 245 posts total