2. tech-talk
  3. 129969-75330

HELP AFTER MY MODS, My tweeters are subdued and weak-

So I have a pair of Mirage M1 speakers, I changed the caps in the crossovers to Jantzen Superior Z (for the tweeters) and standard z for the mids and bass.
 
I also changed the internal cabling to Supra Classic 2.5.

First Impressions-  Not burned in yet
The highs are there but really recessed in the background. Theres a song I reference and it has a steel guitar solo, I can bearly hear it through the vocals because its seems recessed so far back.

SO HERES THE QUESTION- Is that a symptom of unburned in cables and or caps, or is that just what Supra cables give you?

When I changed the internal cabling a few years back on the same model speaker, I used DH LABS t14 Silver plated cable, This had the opposite effect, it was super bright and fast, but it smoothed out and the brightness relaxed, leaving a lot of detail but not so much your ears bled.

But here its the opposite, its dull on the top end and the vocals kind of take over and blur out the top end.

idahifi
idahifi OP
100 posts
 
idahifi OP
100 posts
 
Heres the crossover pics

https://ibb.co/hrQ6oF

http: https://ibb.co/cMfjav
timlub
2,039 posts
 
Thanks for posting the schematic Sean.... I can see a lot more now.... OK, so this is a series crossover,  parts burn in takes about twice as long to burn in rather than a paralleled layout....  Yes,  I had a similar effect on my speakers and no,  I would not change any resistors. 
My instincts are that your ears will take some time to adjust even after these break in.  The Z is a tad more laid back than most, yet a very detailed pleasing cap.  I suspect once they break in fully and you become accustomed to them,  you won't want anything else. 
erik_squires
16,046 posts
 
So looking at the schematic, the two caps I would be most suspect of are C3 and C4. Note they have a resistor in series with them, so the overall resistance there must be important. I would suggest you go back to the original caps there, and listen again.

If this fixes your problem, you’ll want to figure out the ESR of each one by substituting larger R3/R4 to make up the differences.

Almost missed it, C1 is the same way. My suspicion is that the resistors in series are going to be really small , like 2-5 Ohms max. 

Best,

E
timlub
2,039 posts
 
C1 is in the woofer circuit
C3 & C4 are in the midrange
R3 is in the midrange
R4 is comp on the tweeter
I'd put a signal on these and let them burn in for 100 hours or so,  then listen again.  If these are anything, but a nice improvement in smoothness and detail from before the mod,  then there is a problem.  I'd let this play for awhile, then sit down for a serious listen. 

More to discover