Also avoid binding posts. I mod my amp and speakers to only use binding posts as clamps, never to conduct signal. They also degrade sound in very obvious ways once you learn how to bypass them.
Bare wire to bare wire is so much better sounding. Output wires from the amp are clamped to my speaker wire directly. Same thing on the speaker end. Just think about that mass of brass covered in a thin coating etc... Avoid those binding posts! Even the best connectors and posts are bottlenecks. The improvement is shocking folks. Best mod I do and have done.
Since the Duelund wire is tinned it will not oxidaize etc... I use it in my speaker crossovers and amp also.
Bare wire to bare wire is so much better sounding. Output wires from the amp are clamped to my speaker wire directly. Same thing on the speaker end. Just think about that mass of brass covered in a thin coating etc... Avoid those binding posts! Even the best connectors and posts are bottlenecks. The improvement is shocking folks. Best mod I do and have done.
Since the Duelund wire is tinned it will not oxidaize etc... I use it in my speaker crossovers and amp also.