2. amps-preamps
  3. 132245-34152

Aragon 8008x5 with Vandersteen 2w

Hello everyone, 
     I know this is a long shot but is anyone using the above combination. I am attempting to find the correct balanced crossover. I have 20K RCA, 150K balanced, these do not sound good. I do have the WX2 box but believe it is defective. I have downloaded the Vandertones and am using a multi-meter to check AC voltage at the speaker. None of that matters if I do not have various capacitors to try. 

So.... since I do not know the correct input impedance for this amp, does anyone have one they are using successfully with a 2w series sub-woofer?

PS, the advertised spec I found for the amplifier is 22K single ended. The 20K single ended crossover does not sound or measure correctly. I believe the impedance for the 8008x5 may be different from an 8008. Speakers are Vandersteen 2ci.

Thanks in advance!       
jwmorris
csmgolf
887 posts
 
Don't forget to use the xlr shorting pins for the channels that will be used with rca output.
jwmorris OP
46 posts
 
Yes, I am using the shorting pins. Thank you!
gdnrbob
4,444 posts
 
OP, have you corrected the problem?
B
jwmorris OP
46 posts
 
No I have not corrected the issue yet. I am going to take a break from the problem and address it again in the future. I may order a variety of capacitors to wire in and see if that works. I still believe I have a bad WX2 or the amplifier is just not compatible with the sub-woofer system.   

Thanks for asking! If I get it figured out I will let the forum know. 
Post removed 
More to discover