Anyone have/ordered the Job 225?

Kenny is right about the Job being system dependent. The LTA MZ2 did not work well with it, the Decware CSP3 did work well because of the input adjustment. The Job also can occasionally make a big pop sound when it decides to pass a little DC to your speakers.

Anyone compared the Job225 to the Benchmark Ahb2 amp?

It's been a bit since anyone has commented in here, but I was wondering if people still have their 225's, and if so, are they still in love with them?

Got my Job 225 and Pre2 in September and loving them. I think folks are still holding on to their Job, hard to find in the used market back when I was looking. 

Attention JOB 225 Owners!

• Missing that gentle bloom that only tubes can deliver?
  
• Struggling with too much Gain and insufficient attenuation "fine-tuning" range?
  
• Wishing you could tailor the sound just a smidgen, for your room?
  
• Looking for a bit of a project?

Your prayed have been answered.

Introducing... Transcendent Sound THE FIXER (Unit Gain Preamp Kitset)

• Tube-based active circuit (one 12AU7, one 12AX7 and one ECC99)
  
• Four (4) Inputs
• Volume attenuation
• Advanced Bass and Treble controls
• Unity Gain (Zero Gain)
  
• Wide bandwidth design (Flat 15Hz-400kHz)
  
• Low noise (Deathly quiet)
  
• Low cost (Sub $US500)

Available soon from a proven tube amp kitset designer...

https://tubehifi.websitetoolbox.com/post/new-product-the-fixer-is-here-9501427

(No affiliation - just a very satisfied long-term client...)

For all the high end qualifiers thrown its way, for me its a music lover amp. It is not ultimate high end amp. It runs hotter into 4 ohm, I currently use with 8 ohm. I also found it ran a little hotter with a passive versus active. Overall I prefer with active. A keeper, amazing solid state sound.