2. analog
  3. 133813-10289

Is a SUT needed?

I have a Dynavector DRT XV 1s going into an Aesthetix Rhea Signature. The sound is great, but I do have to increase the volume due to the low output of the cart, which can produce a high noise floor, when listening to quieter passages.  Do you think a Dynavector SUT 200 would be a good match?  Any suggestions?
handymann
jperry
2,453 posts
 
Have you tried low noise NOS tubes from Andy @ Vintage Tube Services?

http://vintagetubeservices.com/

You might want to give him a call.
handymann OP
383 posts
 
Thanks for the suggestions. I have my Rhea set at 62 on gain. Any higher and it overloads. Gain isn't the issue, noise floor is. Jperry has the the correct remedy I do believe. I'll call Andy about some tubes. I've spoken to him before-just wanted your opinions.                     Steve. 
jperry
2,453 posts
 
@handymann 

I had a Rhea and at the 62 db gain setting you should not have a noise issue with the right tubes. I bought RCA tubes from Andy on his recommendation that fit in my budget and that took care of noise floor issues.
handymann OP
383 posts
 
jperry:  I too purchased 4 matched RCA 12ax7's from Andy and my noise floor was reduced significantly. Still a little tube rush between songs at high level of playback, but that's just tubes. 
nandric's avatar
nandric
4,086 posts
 

Curious? The tube lovers change the question about ''superiority''

into ''tube kinds''. So, obviously, there are mediocre , better and

superior kinds. Which is which is , alas, not clear.

More to discover