2. analog
  3. 134547-103254

Moving coil and Moving magnet really the same for my cartridge?

I'm using a Hana SH cartridge and enjoying my vinyl once again. The best setting for this cartridge in my phono preamp is 47k set to MC and using the low output. Does this mean, that I could in fact plug my turntable in the MM inputs with the same settings?
markj941
lewm
13,017 posts
 
Raul, Hana SH is a HOMC cartridge. I doubt it has enough voltage output to drive an MM stage, but it might; we need more data for both the cartridge and the phono stage, don't you think?
Ag insider logo xs@2x
rauliruegas
13,050 posts
 
Yes, but the OP did not give you an answer yet.
R.
chakster's avatar
chakster
6,144 posts
 
@markj941 why don't you just plug it into MM input to check it out, no harm for your cartridge or phono stage. I have a few High Output cartridges made by the same company who made Hanna, but mine made in the mid 80s. They can be plugged into MM phono stage, no problem with gain, but i prefer MC input with automatic impedance load on my WLM Phonata Reference phono stage with suts inside. It's lound, but with my low power tube amp it's fine, better than 47k MM input.  
nandric's avatar
nandric
4,086 posts
 

HOMC means much more wire for the coils while reduction of

mass by moving parts by MC carts is conditio sine qua non for

the fast reaction of the moving parts: stylus/cantilever combo +

coils. Obviously (?) HOMC carts are made to be used with MM

phono-pres. This means the same as production of carts for

which one does not need an (expensive) MC phono-pre. But

we need to assume that cart producers know what they are doing.

markj941 OP
53 posts
 
Phono stage is Jolida jd9 III, Hana SH high output MC cartridge.
More to discover